0
What else can I help you with?
Do you need one bulb to replace head lamp for Hyundai accent 2003 low and high beam?
Yes, the 2003 Hyundai Accent takes a dual-beam headlight lamp for low beam and high beam. See sources and related links below for bulb information.
How do you change the low beam head lamp on a 2006 grand prix?
how do you change the low beam head lamp on a 2006 grand prix?
How do you change a low beam head lamp in a 1986 Lincoln Town Car?
TAke the screws out of the retainer ring, then unplug it and replace it.
If your low beam headlights work but your high beam functions fine on passenger side but not driver side where do you troubleshoot?
Change the globe or lamp. H4 type globes contain the high and low beam, so whilst low beam is working OK the high beam part is likely blown.
How do you change the low beam headlight bulb on a 2002 Hyundai Sonata?
How to change the headlamps on the 2002Instead of fighting the limited space behind the headlight, I find it easier to just take out the three screws (two on top, one on the bottom inside) and then pull the entire assembly out. This way you have complete access to the rear area where you replace the actual lamp.
What is the Hbl sw fuse on a jeep?
high beam lamp
Why would your high beam work and not your low bean in your 1999 ford explorer?
Probably the low beam filament in the dual beam headlight lamp is burnt out. See sources and related links below for more information on the headlight lamp.
Does the 2001 dodge stratus have a high beam bulb and a low beam bulb fuse?
No, because the lamp is a dual beam and should be going through the same circuit. See sources and related links below for more bulb/lamp information.
How do you adjust a 2002 Hyundai Sonata headlights?
The manual show it in the back but I could never find the screws to which the manual refers. Here is what I did. The replacement lowbeam lamp only fits correctly one way, with the tab on the top. I kept inserting the lamp, removing, and bending the tab until the beam was'aligned' properly.
When will you place an electric lamp from a convex lens so that a parallel beam of light comes out of it?
To produce a parallel beam of light using a convex lens and an electric lamp, you would place the lamp at the focal point of the convex lens. This will cause the light rays emitted by the lamp to become parallel after passing through the lens. Adjust the distance between the lamp and the lens until the light converges at the focal point and then diverges as a parallel beam.
How do I remove the lens to change my headlamp on a 1993 Mazda 929?
You do not remoye the lens from the front of the car. head lamp bulbs are removed from the back of the assembly from inside the engine compartment. Note that your car has separate high beam and low beam bulbs. the ones toward the outside are low beam. Tip;do not handle the replacement lamp by touching the glass bulb ,only touch the plastic plug.you can damage the surface or connection.
Why is my Esp light on in 2005 Hyundai Tucson?
brake lamp switch failure
