Take the engine shroud of the top of the flywheel - take the flywheel nut off - Put a puller on it and pull the flywheel off remove the old pieces of key and replace with a new one, and reverse process putting it all back together.
sheared flywheel key. youtube has vids... type in mower cord backfires & you'll see instructions on how to fix it.
It is possible that an electric start lawn mower will not start because the starter is not working properly. The ignition may also be malfunctioning.
There are several reasons why your mower will not start. There could be an obstruction in the blade, a petrol mower could be low on petrol or the fuse could have blown in an electric mower.
To start an electric lawn mower, first plug it in and ensure it is connected to a power source. Then, press and hold the safety button or lever while simultaneously pulling the start lever or pushing the start button. This will engage the motor and start the mower.
No spark, no gas, timing off [sheared keyway] remove plug attach wire lay on motor crank it, do you have spark? put a small amount of gas into spark plug hole, replace plug, doe,s it start? misfires ? replace keyway , under flywheel, Where I come from a push mower does not have an engine so it starts when you do.
sears
a rider will or an electric start will.
To start an electric lawn mower, first ensure it is plugged in or has a charged battery. Then, press and hold the safety button or lever while simultaneously pulling the start lever or pushing the start button. Release the safety button once the mower is running.
Not on a push mower that has no electric start. On a riding mower, yes there is an ignition key.
To start an electric mower, first ensure it is plugged in or has a charged battery. Then, press and hold the safety button or lever while simultaneously pulling the start lever or pushing the start button. Once the mower is running, release the safety button or lever and begin mowing.
My electric lawn mower was working just fine, however in the middle of mowing the yard it would not restart. What could be wrong?
Probably a rusty flywheel and coil contacts. Take cover off and sand them.