0
What else can I help you with?
Can the bestway 12ft x 4ft pool connect to a heater?
Yes it can, you can either us a bestway or intex 3kw heater.
What is the fuse rating for 3kw immersion heater?
The fuse rating for a 3kW immersion heater is typically 13 amps. This is based on the formula that calculates the current draw (I) using the power (P) and voltage (V): I = P/V. For a standard UK voltage of 230V, a 3kW heater would draw approximately 13 amps. It's important to ensure that the circuit is also properly rated to handle the load.
What is the fuse rating for a kettle?
A standard 3kW immersion heater will require a fuse rating of 13 A. This is because, it draws a current of 12 A.
How long will a 3kw heater take to heat a 16ft pool?
3kw heater heating a 10 foot pool may take 4 to 8 hours for heating it up to 20 to 25 Degrees Celsius. This also depends on the outside temperature.
What size fuse is needed for a 3kw heater?
A 13 Amp fuse (brown) is needed for a 3kw heater. <<>> Answer for USA, Canada and countries running a 60 Hz power supply service. 3000 watts at 120 volts = 25 amps, 3000 watts at 240 volts = 12.5 amps.
How many degrees will your heat pump raise the temp of your pool?
i have a 5ft pool and have a intex 3kw heater how long will it take to heat pool to a good swimm tempature
What size of wire you need to feed commercial kitchen equipment three 3kwovens a 20kw water heater and 3kw deep fryer?
You should contact a certified, and licensed electrician.
What size of wire use for 3kw motor 380volts 3phase?
How to calculate a cable size of 3kw motor
What protective device should in the consumer unit be rated for a 3KW immersion heater use?
For a 3kW immersion heater, a protective device such as a circuit breaker or fuse should be rated at least 13 amps to safely handle the load. This is calculated by dividing the power (3000 watts) by the voltage (usually 230V in residential settings). It is important to ensure the protective device is properly sized to prevent overheating and potential hazards.
Where should the supply for a 3kW immersion heater originate from?
junction box
What would be the resistance of and the current drawn by a 3kw 240 v immersion heater?
Power = E2 / RResistance = E2 / power = (240)2 / 3,000 = 19.2 ohmsCurrent = E / R = 240 / 19.2 = 12.5 amperes
How much watts for 2 ton AC?
3KW
