It's clean and unlimited
Two. Dry-er.
I removed the switch today 6 July 08. There were two screws in the back of the washer attached to the hinges which allow the top of the dryer to open. Two screws that hold the lint trap to the inside of the dryer and two screws that hold the dryer door switch. After you remove all of the screws you can lift the dryer top from the front and it will rotate on the hinges in the back. Then you can unplug the switch and plug in a new one. Hope this helps.
Yes, typically electric dryers require two 30 amp fuses to operate properly. These fuses protect the dryer from electrical overload and should be installed in the dryer's electrical circuit. It's important to check the dryer's manual or consult with a professional to ensure the correct fuses are used.
The main advantages of a portable washer and dryer combo is two fold. One the washer and dryer remain compact and together, and second it is portable so one can take it anywhere.
Fred Dryer
hybrids are produced when two different species interbreed
A dryer needs four wires for proper operation and safety because it requires two hot wires, one neutral wire, and one ground wire. The ground wire helps protect against electrical shocks and ensures proper functioning of the appliance. It is a standard requirement to have all four wires for dryer installations to meet safety regulations.
No you can only have one dryer on a 240v circuit and nothing else can be attached to it either considering your using a 240v electric dryer
Dryer sheets often contain chemicals such as phthalates, which can have negative effects on respiratory health and skin irritation. When disposed of, dryer sheets contribute to environmental pollution through the release of harmful chemicals into waterways and soil.
There are two circuits in your dryer. One runs the motor, the other the heating element. Something in your heating element circuit is broken, and the most likely culprit is the element. To check it, unplug the dryer, take the back off, find the element, disconnect one of the two wires and put an ohmmeter across the two connections. If it reads infinity, change the element.
The Rams' Fred Dryer in 1973 against the Packers.