After all the wires are connected in "Escape the Car," you typically need to ensure that the connections are secure and follow any specific patterns or sequences indicated in the game's clues. Once everything is properly connected, you would usually need to interact with the car's ignition or control panel to start the engine or unlock the doors. Pay attention to any additional prompts or puzzles that may arise to successfully escape.
Pink, blue, green, and yellow
it is out of time or the plug wires are connected incorrectly.
It should be on the transmission by the passenger side of car. It has three wires connected to it.
It just goes to a ground point, either on the body or on the frame.
buy new ignition wires
it is in under the car, in the front part of the exghaust it's the only part with wires connected to the exghaust.
is the car on? do you have the signal on? is there a bulb? are there wires connected to the bulb? or just go to a mech and have him figure it out. simple.
I would check your wiring You most likely have some wires connected to the same source
Check your wire connections. If the wires are out of order, it may prevent the car from starting.
if your car has a factory amp you might have to mess around with the factory remote wire(this is what tells the amp to turn on) good luck
Backfiring it normally caused by a car that is very badly out of time. It can also be caused by the spark plug wires being connected incorrectly. Switching to a higher octane will not help at all.
Timing is way off or spark plug wires incorrectly connected.