this is a circuit in which the switch is located before the load in the circuit
The current flows from negative to positive.
A variable resistor can be used to control the current in a circuit by adjusting its resistance. By changing the resistance value, the amount of current flowing through the circuit can be regulated.
meaning that the current from your power source doesn't return to the positive end (electricity flows from - negative, to + positive)
every electronic circuit works on the principle of direct current .hence from negative to positive.
In a circuit, the purpose of a switch is to control the current flow to the load by opening the circuit (off) or closing the circuit (on). When the circuit is open, the is no complete loop through which the current can flow. When the switch closes the circuit, it restores the loop, and thus allows the current to flow.
In a circuit, DC current flows from the positive terminal of the power source to the negative terminal.
current amplifier
The positive terminal in an electrical circuit serves as the point where current flows into the circuit from an external power source, providing the energy needed for the circuit to operate.
In a DC circuit, the direction of current flow is from the positive terminal of the voltage source to the negative terminal.
Direct Current Positive - the starting point at which the electrons flow through the wire circuit. These electrons are fully charged, ready to expend their energy into the various points in the circuit, be it a lightbulb etc Direct Current Negative - the return point of the finished electrons into the battery to collect more energy to enter the circuit again.
Conventional current is used in electronics to represent the flow of positive charge from the positive terminal to the negative terminal of a battery. It is used to simplify circuit analysis and design. It helps in understanding the direction of current flow in a circuit.
always current flow from the opposite direction of electron