next to driver on right
If the handbrake assembly is working properly it shouldn't.
No
I have been given a courtesy car but I am having problems taking off the handbrake. It is an 02 car. What can I do?
Because you probably still have your handbrake on. If not, than you need to see the car-doctor.
I have the same car. I just realize it has a automatic handbrake when shift the gear to park
To adjust the handbrake on a Citroën Xantia, first, ensure the car is on a flat surface and securely lift it using a jack. Remove the rear wheel and access the brake mechanism. Adjust the handbrake cable tension by turning the adjusting nut located near the rear of the handbrake lever until the desired tension is achieved, making sure the handbrake holds the car when engaged. Finally, test the handbrake by lowering the car and ensuring it holds securely on a slope.
your switch that tells the car that the brake is off is defective
Handbrake Turn
beacause the smart car are smart
the handbrake cable splits into two under neath the car. To adjust the handbrakes, alter the adjusting bold ratio at the bottom and on both sides of the car.... You can also remove the cover off the handbrake cable and tighten to size 10 bold that links the cable to the mechanisim inside the car
To replace the handbrake cables on a Peugeot 307, start by lifting the car and removing the rear wheels for better access. Disconnect the old cables from the handbrake lever inside the car and from the brake calipers at the rear. Install the new cables by attaching them to the calipers first, then connect them to the handbrake lever, ensuring they are properly routed. Finally, adjust the tension and test the handbrake for proper operation before reassembling everything.
it culd be that u have problems with the hand break calbe, or the diferential