Oh, dude, that's probably because the smart window feature on your convertible PT Cruiser is not functioning properly. It could be due to a faulty sensor or a malfunction in the window mechanism. You might want to get that checked out by a professional before you end up with a permanently open or closed window situation.
I wouldn't.
The rear window of your 1998 BMW 323 convertible can be replaced. Most BMW dealerships service department will replace the window.
Check that your doors close completely (windows do not hang up on the convertible top). Also after your battery has drained or cables removed (to charge or replace battery) the power windows on the convertible model must be "retrained" to close correctly. The procedure is in your owner's manual but basically it is to sit inside the vehicle with door closed and lower the window then raise. When the window is fully closed do not remove your finger from the "up" button but keep depressed for approx 25 seconds. If properly done and assuming the battery has enough charge, when you open door the window should lower automatically a fraction to clear the convertible top then automatically raise when the door is shut. Do the same for the passenger door.
Power the window all the way down then hold it for five seconds after its completely down. then power the window all the way up and hold it for an additional five seconds. The convertible top should be up during this window 'reset'.
it is riveted in.
No
A vinyl window in a convertible top refers to a flexible, transparent panel made from vinyl material that is integrated into the soft top of a convertible car. This window allows for visibility while maintaining the convertible's sleek design and weather protection. Vinyl windows are typically less expensive than glass options, but they may be less durable and can scratch or cloud over time. They are commonly found in older convertible models and some budget-friendly newer ones.
To replace the rear window on a 1996 Sunfire convertible, first, carefully remove the old window by cutting the adhesive sealant with a utility knife. Clean the area thoroughly to ensure a good bond for the new window. Apply a new adhesive sealant around the window frame, then carefully position the new window in place, pressing it firmly to ensure a secure fit. Allow the adhesive to cure as per the manufacturer's instructions before using the convertible top.
Is there a separate fuse for every electric window in the 1999 landcruiser and if there is where are they.
To repair the window in a 2000 Z28 convertible, first, remove the door panel to access the window mechanism. Check for any broken components, such as the window regulator or motor, and replace them as needed. If the glass itself is loose, ensure it's properly secured in the regulator. Once repairs are made, reassemble the door panel and test the window operation.
To install a rear window in a 2002 Toyota Solara convertible, start by carefully removing any old or damaged window material and cleaning the area. Use a suitable adhesive recommended for automotive convertible tops to secure the new window in place, ensuring proper alignment. Once positioned, press the window firmly into the adhesive and allow it to cure according to the manufacturer's instructions. Finally, reattach any trim or components you had to remove during the process.
The convertible top, window mechanism (cassette) and more