I drove under high tension wires in a truck and could clearly hear a buzzing noise. I actually stopped the truck and sat under the wire for a moment to listen to the sound. As I recall it was a very humid day. I don't know if this is true but suspect the damp air had something to do with it.
white wires are neutral. green wires are ground wires.
Yes, the plastic in a wall outlet can over time get brittle. I recommend you replace any outlets and switches that are over 20 years old. I recommend you replace them and wire them by wrapping the wires around the screws and not by inserting the wires in the spring tension holes on the back of the outlets. An outlet that is subject to repeated plug ins and unplugging of a device should be replaced every 10 years.
yes wires is electrical panel
If you mean 2 bare copper wires those are the ground wires. Tie them together and then connect the light fixture ground wire which will be green or bare copper to those ground wires.
Electric wires are manufactured in various ways. One of the most common methods is the strip twist where wires are enhanced to hold mechanical loads.Ê
the current causes alternating magnetic fields which shake the wires and they get warm so snow and rain sizzle off the wires.
High Tension Wires was created in 1989.
To improve the sound quality of a cajon, you can try adjusting the tension of the strings inside, experimenting with different playing techniques, and adding external accessories like snare wires or foam to enhance the sound.
Technically, yes. However, a headphone jack does not provide a great deal of power, so you would probably need an amplifier for the sound output to actually be audible.
High tension electrical wires
27,572
Grasp the plug wire by the boot then rotate and pull at the same time. Pay attention also to the angle of the sleeves that the boots are in, it may sound stupid but pull with the angle. When reinstalling the plug wires, there should a audible "click" when the boot is successfully installed on the plug. Generally the new plug wires come a sheet of instructions. Don't forget to mark the wires for correct replacement if pulling more than one at a time.
1.The wind blows hard to create a sound so when the wind blows the wires start shaking and making another sound so together they make a loud sound. 2. When the wind blows through the telephone wires the wind blows the wires forcing them to vibrate. so technically because the wind makes the telephone wires vibrate. your welcome.
engine pulls the aircraft forward but air resistance tries to hold it back results in tension which tries to stretch..............2)bracing wires are subjected to tension
They are to make the high tension wires visible from a distance.
A word relating to electricity is high tension wires.
Wires is a diphthong. It has only one syllable but can sound like it has two.