Quality can not be expressed as the ratio of the volume occupied by the vapor phase to the total volume. The exact definition of quality is "In manufacturing, a measure of excellence or a state of being free from defects, deficiencies and significant variations.
If the input and output are expressed in volts, then negative gain means a 180° phase shift. If the ratio of output to input is expressed in dB, then negative gain means attenuation, i.e., less power out than power in.
BHP stands for 'brake horsepower', and simply means it is describing the output, rather than the input, power of the machine. Although a motor's output power is expressed in horsepower in North America, elsewhere it is expressed in watts.
Yes, there is a difference between single phase and three phase circuits.
because y phase is y phase ...it is not b phase or R phase so it is high
short circuite means phase to phase,three phase short, phase to earth, three phase to earth, this is all short circuite
ø in an emulsion the relative volume of water and oil is expressed as phase volume ratio. ø in general most medicinal emulsion are prepared with a volume ratio of 50:50. ø this proportion brings about loose packing of globules. ø uniform spherical globules in loose packing have a porosity of 48% of the bulk volume. ø the remaining volume 52% is occupied by the globules.
Volume is the amount of space something takes up. It doesn't matter what phase the matter is (gas, liquid, etc). The specific 3-dimensional space occupied is the volume.
Total slots per phase =12/3=4 slots to be occupied. Slots per pole per phase = 12/(3*4)=1 hence for A phase, the slots to be occupied are 1,4,7,10;for B phase, the slots to be occupied are 5,8,11,2;for C phase, the slots to be occupied are 9,12,3,6 and winding to we wave type.
The gas phase.
Assuming you mean "phase", it is usually expressed in angular units - degrees, or radians.
Solids are the only phase of matter which have a fixed shape and volume.
This phase is a liquid.
system volume is amount of mobile phase travel from reservior to tip of the colomn . dead volume is the amount of mobile phase present in colomn. delay volume is amount of mobile phase used in at the time of injection and the time of detection of chromatogram.
For a single-phase transformer, divide the ratedapparent power (expressed in volt amperes) by the voltage rating (expressed in volts) of the primary winding; this will give you the rated primary current (expressed in amperes) of the primary winding.
a solide has a shape of its shape and volume
a solide has a shape of its shape and volume
a solide has a shape of its shape and volume