0
You can if done carefully. The neutral of one transformer must be set up to be at the positive voltage of the other transformer. This might require an intermediate step transformer that is center tapped (so three instead of 2 Transformers).
What else can I help you with?
Voltmeter in series circuits?
The only reason anyone will put a voltmeter in series is to measure current flow as a function of voltage drop.
Biased series positive clipper?
biased series clipper has more than one bettries and voltage out put is across resistance
When capacitors ate connected in series the capacitance increase or decrease?
Capacitors in connected in series result in a higher voltage rating, but lower capacitance. Two 470uF 50V capacitors connected in series will give you a total of 235uF, but you can put up to 100V across the series combination. Two 470uF 50V capacitors connected in parallel will give you a total of 940uF, across which you can put 50V (the voltage rating does not change for capacitors in parallel).
You have 480 volts coming into a stepdown transformer that is set for 440 volts incoming power would this cause your output voltage to be higher than 120 volts?
In short, probably. Transformers step power up or down by a multiplicative factor based on the number of turns in the two transformer coils. Therefore, if you put more voltage in you're going to get a proportional increase in the voltage out.
What is a protective resistor?
The protecting resistor is put in series with the LED so that you have a voltage divider - the supply voltage is split across the LED ( max 0.6v) and the remainder across the protecting resistor. So if your supply is 6volts, 5.4v will be across the resistor,
How can you convert 1000000 volts to several hundred 9 volt power sources?
On the whole AC electrical conversions are done with transformers. In your question both step up and step down transformers will be utilized. Step up transformers will be utilized to get the generated voltage up to transmission voltage. At the voltage transmission destination the voltage will use step down transformers to decrease the voltage to the consumers load requirement. Or you could connect 111111 resistors in series and take the voltage off each one of them .. but ull have to put in consideration the load resistance ..
How many batteries needed in a series circuit?
It depends on the load and desired voltage. The voltage adds as you put batteries in series. Positive to negative, etc.
How do you use a resistor to lower ac voltage?
ummmmm... put it in series.
Why is there no Hotshot in the Transformers movie?
Hotshot isn't the only transformer that is missing in the movies that is present in the other series. If they were to put all of the transformers in the movie there would be way to many of them.
Is there a rule to distance of cable from a power source to low voltage lighting without voltage drop and do you have to put transformers or outlets in the yard?
Voltage drop depends on the size & length of the wire and the wattage of the bulbs. If they make an LED replacement bulb , you would hardly notice the voltage drop.
Can you put two 5v voltage regulators in series to get 10v?
No, you cannot put two 5V voltage regulators in series to obtain 10V. Voltage regulators are designed to maintain a constant output voltage regardless of the input voltage, and connecting them in series would not sum their outputs as you might expect. Instead, it could lead to instability or damage to the regulators. To achieve 10V, it's better to use a step-up (boost) converter or a dedicated 10V regulator.
Voltmeter in series circuits?
The only reason anyone will put a voltmeter in series is to measure current flow as a function of voltage drop.
Biased series positive clipper?
biased series clipper has more than one bettries and voltage out put is across resistance
On a step up transformer if the input is 200 Hz will the out put also be 200 Hz?
Yes. Transformers affect the current and voltage of the applied power. The frequency will remain the same.
Why would you add batteries in series?
Putting batteries in series will up the voltage of the entire circuit. Certain things need higher voltage, so you put your batteries in series. Putting batteries in parallel will not up the voltage, but will let the current last longer. Watches would be more of an example for that. You want watch batteries to last long.
Why do you build solar cells in both parallel series and series configurations?
Solar cells in parallel series configuration are used to increase the current output, while solar cells in series configuration are used to increase the voltage output. By combining these configurations, you can optimize both current and voltage levels for a specific application, such as maximizing power output in a solar panel.
Where do you put the cheats for transformers revenge of the fallen?
just google transformers revenge of the fallen cheats
