answersLogoWhite

0


Best Answer

This is a device of High Voltage (HV) Alternating Current (AC) measurement. Connect the HV AC source through a capacitor to either a full or half rectifier. In comparison to the HV the diodes in the rectifier can be concerted ideal. Under the rectifier connect an ammeter. The formula is V p-p = Iave/(2FC) for a half rectifier and V p-p = Iave/(4FC) for a full rectifier. Where V p-p is the peak to peak voltage, Iave is the average current, F is the frequency of the AC and C is the capacitor used.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Chubb and fortescue method for HV AC mesurement?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the preferred method for conducting a route reconnaissance?

The AC method.


Write down the advantage of 2-wattmeter method instead of 3-wattmeter method for measuring ac power?

It's cheaper.


Is there any method to store ac power?

You can store energy in a rotating mass such as a flywheel (there are flywheels under development that are equivalent to a few megawatts and more of instantaneous power). When you get the energy out of these devices, it will be AC.


How do you factor this equation using the ac method 4x3-19x2 plus 15x?

x(x - 1)(4x - 15)


What is method for converting dc into ac supply?

An 'inverter' takes direct current (DC) input from a battery and outputs alternating current (AC). This means that an electric drill that should be plugged into the mains, can be run from the inverter.


Is there a DOT requirement for drivers of an emergency vehicle such as an electric bucket truck to have some method of cooling or AC in the truck?

It depends on the state, there are a few stated that require all commercial vehicles to have AC however, most do not require it.


Where to Buy Chillwell Portable AC?

Buying a Chillwell Portable AC unit from the association's actual site is the best method for ensuring that you're getting a genuine thing.Expect you are excited about purchasing a one of a kind Chillwell Portable AC. In light of everything, we recommend that you use the association gave in this Chillwell Portable AC Review to investigate to the maker's site and make your purchase there.


How do you change AC into DC and DC into AC?

In most circumstances a full wave diode bridge is used to convert AC into DC. Along with inductors and capacitors used as filters, the DC ripple is smoothed out to a very stable DC voltage. This is the method used in DC power supplies. To convert from DC to AC an inverter is used. Today most inverters use the modified sine wave method which brings the sine wave closer to a AC generated sine wave. Older inverters used an on - off switching procedure to generate a square sine wave. Modern electronics do not work well with square wave generation.


How do you simplify a to the 3rd power times c to the 2nd power divided by ac?

Correction: a3c2/ac = a2c method: a3c2/ac = a x a x a x c x c / a x c = a x a x a x c x c / a x c = a x a x c = a2c


Does the battery method have any limitations on testing the transformers polarity?

yes its does the higher the current will blow out the transformers


Describe the analytical method of finding the resultant of vectors?

you calculate the displacement using this formula ac+mx-b=0 by mr erick louie alcantara sison


What is the most effective braking method for ac motors?

DC injection breaking where a DC voltage is applied to the motor's coil windings.See sources and related links below.