answersLogoWhite

0


Best Answer

300nm is the "wavelength". Wavelength and frequency are related by the following equation: λ = v / f Where λ (gamma) is the wavelength, v is the speed of the wave (typically c, the speed of light (3×10^8 m/s)), and f is the frequency. So f = v / λ. So a 300nm wave, (λ = 300*10^-9 m) has a frequency of (3e8 / 300e-9) = 1e15Hz or 1,000THz. 500nm: (3e8 / 500e-9) = 6e14Hz or 600THz. See link.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Does 300nanometers have a lower frequency than 500nanometers?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Electrical Engineering

Is low bandwidth signal has more power than high bandwidth signal?

no,because generally the lower frequency side existed for lower bandwidth,and higher frequency side existed higher bandwidth,so thus we can say that lower bandwidth has generally has lower power as compared to higher bandwidth.


What is the need of under frequency relay in load shedding on power system?

when the load on a certain system increases the frequency of the system falls normally. It is dangerous to operate the equipments when the frequency is lower than the normal rated frequency so shed the when the frequency falls under voltage relays are used. I hope i answered your question :)


How High pass filter circuits works?

A High Pass Filter is an Electronic Filter that passes high frequency signals but Attenuates (reduces the Amplitude ) of Signals with frequencies lower than the cut-off Frequency


For satellite communication the frequency should be less than critical frequency?

For satllite communication the frequency should not be less than the critical frequency because in satellite communicaton high frequency is needed which is reflected by satellite but not by the ionosphere.


Why must the oncoming generator on a power system be parralleled at a higher frequency than that of the running system?

If the frequency of the oncoming generator is slightly higher than the system frequency, the phase angle between the system and generator voltages will slowly change at a frequency equal to the difference between system and generator frequencies.