0
What else can I help you with?
What is feeder wire?
The feed line is the cable or other transmission line that connects the antenna with the radio transmitter or receiver
Difference between strobe and handshake signal?
A strobe signal is sent by the signal sender without any regard to the signal receiver. This assumes that the design provides sufficient setup and hold time, along with transmission time, to ensure reliable receipt of the signal. A handshake signal is a bi-directional protocol between the signal sender and the signal receiver, which the receiver uses to tell the sender that the signal has been received. In this system, it often does not matter what the transmission time is, but bandwidth can be reduced since the sender must wait for the handshake to come back from the receiver, effectively doubling the time it takes to send a signal.
Why the linear combination of a low frequency intelligence signal and a high frequency carrier signal is not effective as a radio transmission?
to shift the frequency of information signal ,at the frequency domain to a higher frequency ...so the information can be transmitted to the receiver.
What is broadcast receiver?
A broadcast receiver is a radio that receives broadcasts from commercial radio stations.
What is telestimulation?
Telestimulation systems are described for chronic indirect muscle stimulation in caged rabbits and mice. Both system use a 5 MHz carrier frequency transmission and consist of a transmitter and a receiver. The latter is fixed to the back of the animal.
What does electricity receiver mean?
An electricity receiver is a device that receives electrical power from a power source or grid. This can include devices such as electrical outlets, power strips, or any equipment designed to draw electricity for operation.
What is data cable?
Just as electric cable transmits electric line power from the transmission center to receiving station so the data cable in digital communication transmits the encoded binary digits from a digital transmission system to a digital receiving system.
What two functions does an antenna performs?
An antenna functions to receive electromagnetic signals from a transmitter and convert them into electrical signals for a device to process. It also transmits electrical signals from a device into electromagnetic signals to be sent to a receiver.
Block diagram of microwave communication link?
A microwave communication link typically consists of a transmitter, a receiver, and an antenna at both ends. The transmitter converts the electrical signal into microwave signals, which are then transmitted through the antenna. The receiver at the other end captures these microwave signals through its antenna and converts them back into electrical signals for further processing. The link may also include devices such as amplifiers, filters, and antennas to enhance signal quality and transmission.
A data transmission which involves only one transmitter and one receiver is known as?
Point-to-point transmission
Will an RCA satellite receiver work in Turkey?
Probably not. Different TV transmission standards and different satellite transmission systems.
What are the advantages of digital and analog transmission?
digital transmission changes information to numbers adds a checksum or hash so if there is a transmission error or receiver error the receiver can call the transmitter and tell it to resend analog transmission modulates the info onto a carrier and casts it to the winds the receiver picks it up and gotta live with it if there is a lightning storm around and you think you didnt understand you can call the transmitter(DJ) and tell him to resend
WHAT IS THE what is the Use of satellites in tv transmission?
it is used to transmit information from the provider to a requesting receiver.
How does the receiver sync up in synchronous transmission?
using chuck norris' beard and awesomness
What energy conversion takes place in a transmitting and receiving antenna?
In a transmitting antenna, electrical energy from the transmitter is converted into electromagnetic radiation (radio waves) for transmission. In a receiving antenna, electromagnetic radiation from incoming signals is converted back into electrical energy for the receiver to process.
How is sound transmitted and received via telegraph?
Sound is transmitted via telegraph by converting sound waves into electrical signals. These electrical signals are then sent through a telegraph wire to a receiver on the other end. The receiver converts the electrical signals back into sound waves, allowing the message to be heard.
Asynchronous transmission and not to use any stop elements?
Can a sender and receiver use asynchronous transmission and agree not to use any stop elements?
