answersLogoWhite

0

What else can I help you with?

Related Questions

What are the different splice of wires?

The five most known are the rattail joint, the western union, the fixture joint, the knotted tap and the staggered splice. Then there are crimping, wire-nutting, soldering, sty-cons.


What are the different kinds of splice?

The five most known are the rattail joint, the western union, the fixture joint, the knotted tap and the staggered splice. Then there are crimping, wire-nutting, soldering, sty-cons.


Different kinds of splices and joints?

The four types of splices and joints are the Western Union splice, tap splice or tap joint, fixture splices or fixture joints, and rattail joint. The most common among the four wire splices is the Western Union splice.


What is electrical splice?

The joining together of two or more conductors in an electric circuit.


Can you splice into a wire in mid-run or doi need to add on to the circuit from the end of the run?

As long as all the existing wiring is adequate for the anticipated loads, there's no electrical difference regardless of where you make the physical connection to additional wiring.


How do you change a tail light bulb holder for a 1994 Pontiac grand am?

Cut the wires on the old fixture and splice wires from new receptacle


What are the different kinds of wiring splices?

The five most known are the rattail joint, the western union, the fixture joint, the knotted tap and the staggered splice. Then there are crimping, wire-nutting, soldering, sty-cons.


Which wires do you splice to connect lights for a utility trailer on a 2005 grand caravan?

You can use "Scotch locks" on the tailights, and stop lights - trace them from the rear light fixture


Can you break a three phase from a disconnect?

If you mean can you splice in a second circuit from the load side of a three phase disconnect then the answer is no.


What are the different wire joints?

The electrical splice and joint types are the Western Union splice, tap joint or splice, fixture joint or splice, and the rattail joint. The splices and joints are used to connect two pieces of wires to carry an electrical signal or current.


How do you splice thermocouple wire?

One splice that would work is a western splice.


What is wrong with taping a broken wire?

There is nothing wrong taping a broken wire. As long as the wire connection is made with an approved mechanical device, the splice can be taped. With broken wires, usually the conductor is put together again with a butt splice. On larger size conductors the butt splice is just bare metal. This type of splice has to be tapped. The code rule states that the tape insulation must be brought up to the insulation value of the existing insulation factor.