This can not be answered with the information you have given. 60Hz does not relate the the current draw so wire size can not be calculated.
A capacitor does not increase amps; instead, it stores and releases electrical energy. In an AC circuit, capacitors can influence the current flow by affecting the phase relationship between voltage and current, which can lead to higher apparent current (amps) in certain conditions. However, they do not increase the actual current supplied by a power source. The overall current still depends on the power supply and the load connected to the circuit.
Your 2-wire system is actually connected to one "side" of the 3-wire system. In your utility's 3-wire system you have 2 hot wires that are attached to each end of a tranformer winding and the neutral is attached in the middle and grounded. Typically in the US this gives you 240v (or something similar) between hot leads and 120v from each hot lead to neutral or ground.
A multimeter, also called a VOM, is an ohmmeter, ammeter, and voltmeter combined in one case. A function knob can be turned to select the type of measurement to be made, such as volts, amps, or ohms. The multimeter's test lead connections to the circuit will depend on whether you are using it as a voltmeter, an ammeter, or an ohmmeter.
12 volts only refers to the voltage, to be able to say anything about charge time you also need to know the capacity rating in amp hours of the batteries. Assuming lead-acid batteries the charger needs to go to > 14.4 V and then a proportional amount of amps as compared to the capacity rating of the batteries. A rough approximation is that batteries needs to be charged with about 1.4 times their amp rating. An 1 Ah battery would need 2 hours on a 0.7 amp charger for instance.
lead
An extension lead is an electrical cable which allows one to use a plug-in device away from the wall-socket.
Hair extensions Extension lead House extension
An extension lead has a plug on one end and a few sockets on the other end. They are used to reach appliances that are far away from the main sockets. It is very safe to use an extension cord as long as you don't overload them.
If your extension cord is truly a 30 amp cord then it is composed of #10 wire. #10 wire is rated at 30 amps. All you have to do is remove the 30 amp plug and receptacle ends from the cord and install 15 amp cord ends.
Behringer amps are electric guitar amplifiers. They are used to amplify the sound of the guitar. There are different models for bass guitar and lead guitar.
try your local cooperative extension
Frequencies higher than 60Hz are frequently used. Although there are radio waves lower than 60Hz, all of our radio transmissions are well above that. If you mean why frequencies for mains power supply above 60Hz can't be used, the answer is, they can. The higher the frequency though, the higher the loss although this doesn't really come into play until frequencies above several hundred Hz are used. 50Hz or 60Hz were chosen originally because of the mechanical nature or early generators.
Yes, extension cords can get wet, but it is not safe to use them when they are wet as it can lead to electric shock or damage to the cord. It is important to keep extension cords dry and away from water to prevent accidents.
depends on the kind of aux on the amp or the lead of the headset
Running 50Hz and 60Hz in the same conduit can cause interference or noise issues due to differences in frequencies. These can lead to operational problems in electrical equipment, data transmission issues, or even potential damage to sensitive devices. It is recommended to separate the wiring for different frequencies to avoid these issues.
my plays in a band and is a lead guitar player, my concern is can he continue with this and do amps create any problems
Follow your heart, it will lead you to the right decision