It depends on the frequency. At 60 Hertz, with an ordinary two pole synchronous motor, you cannot have an RPM that is greater than 1800, so a six thousand RPM motor has to have a different power supply.
The two main factors are the frequency and the number of poles of the motor. A formula for RPM is HZ x 60 x 2/ number of poles the motor has.
Name plate data should indicate the number of poles / RPM. For speed N= (120 x Frequency) / Number of poles Using this formula you can find out the number of poles, provided you have other parameters available. If no data is available, run the motor on no load, and measure the rpm, know the frequency, calculate the poles.
It depends on the number of poles and the frequency of the power. A two pole motor running on 60 Hz would rotate at 1800 RPM.
Materials for producing 2900 rpm motor is less than 1450 rpm one
because N=(120*f)/P where N= speed in rpm f= frequency in Hz P= no. of poles as the relations shows above it is cleare that speed of machine inversly proportional to no. of poles.. so as the poles increses, speed of the machine decreses
The number of poles in a 1200 RPM AC motor can be determined using the formula: RPM = (120 × Frequency) / Number of Poles. For a standard frequency of 60 Hz, the equation rearranges to Number of Poles = (120 × 60) / 1200, which results in 6 poles. Therefore, a 1200 RPM AC motor typically has 6 poles.
The formula for RPM is ; RPM = Hz x (120 (constant)) divided by the # of poles. Number of poles a motor has; # of poles = Hz x (120 (constant)) / RPM.
Relationship between motor rpm and no of poles
The two main factors are the frequency and the number of poles of the motor. A formula for RPM is HZ x 60 x 2/ number of poles the motor has.
Motherf****r I Dont Know B****
The formula for RPM is, RPM = Hz x 60 x 2/# of poles the motor has. To answer this question more information needs to be stated.
To calculate the speed of an induction motor use the following formula, RPM = Hz x 60 x 2/motor # of poles. To answer the question, most of the motors must have 4 poles.
It is based on the RPM of the motor. Use the following formulas for 50 and 60 Hertz. The mathematical formula is Frequency in Hertz times 60 (for seconds in a minute) times two (for the positive and negative pulses in the cycle) divided by the number of poles. For 60 hertz, the formula would be, 60 x 60 x 2 = 7,200 no load RPM divided by the number of poles will give you the nameplate RPM of the motor. eg from above formula 7200/2 pole = 3600 RPM, 7200/4 = 1800 RPM, 7200/6 = 1200 RPM
Name plate data should indicate the number of poles / RPM. For speed N= (120 x Frequency) / Number of poles Using this formula you can find out the number of poles, provided you have other parameters available. If no data is available, run the motor on no load, and measure the rpm, know the frequency, calculate the poles.
Speed (RPM) = 120 x f / p f = frequency p = number of poles. 2 poles, speed = 3600 RPM 4 poles, speed = 1800 RPM
No, the nameplate RPM rating is governed by the amount of poles that a stand alone motor has. There are devices in the market place that can be used to control the motors speed but these are after market devices.
No. With the values given the motor will run at 1500 RPM. RPM = Hz x 60 x 2/# of poles. The only way the motor can be run at that speed is by using a VFD as its source of power.