answersLogoWhite

0

The Percentage Efficency for an amp is calculated via the following formula,

Percentage efficency = (0.5÷amperage)×100

= (0.5÷1)×100

= ± 10%

User Avatar

Wiki User

15y ago

What else can I help you with?

Continue Learning about Electrical Engineering

How do you know if your ground wire is connected?

Measure the ground resistance from the user end point, where earth or ground cable is connected. It will show a very high resistance or open if ground is broken.


Why rated voltage is to be applied to primary for open circuit test?

Open circuit test on a transformer is usually performed to measure the IRON losses.Iron losses are produced due to eddy current and hysteresis losses. In open circuit test, the LV side, generaly the secondary winding, is kept open and the HV side, generaly the primary winding is fed with the rated voltage and frequency. The rated voltage is applied in order to setup normal flux in the transformer, which in return further produces the normal iron losses at rated voltage. the wattmeter connected at the primary side will show the power consumed due to iron losses. this calculation further utilized for determing the efficiency of transformer.


What terminals combinations would show an open circuit if the internal overload device in a hermetic compressor should open due to excessive heat?

common to start and common to run


What is burnout protection in temperature transmitter?

Transmitter burnout means failure due to some unknown reasons. Burnout direction means what would you like, your transmitter to output when it fails show maximum value (i.e burnout in high direction) or make it show minimum value (i.e burnout in low direction ). The type of burnout direction would depend upon the different factors such as quality of product, safety of personel, equipment protection.


What is the drawing symbol for a baseboard heater?

Hot----------------/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\------------Common This is the symbol for any electric heater. The controlling device would be noted as --------I I-------- denoting the Normally Open contacts of a relay and the would be wired to the Hot side. I cannot show you the symbol for a thermostat due to keyboard limitations.

Related Questions

What does it mean Percent style format?

It will show the number as a percentage. If you have 5 in a cell and format it to Percent Style it would show as 500%. If you had 0.73 in a cell and formatted it to Percent Style it would show as 73%.


What unit would you use to measure the length of a television show?

You would typically use minutes to measure the length of a television show.


How do you calculate the efficiency of a equipment?

you take the fuel consumption times the amount of matter moved, then you divide the PRODUCT OF THAT BY THE WEIGHT OF THE MACHINE. answer should show up in a percent


What to show 25 percent on a circle graph the section must measure what angle?

25% of 360 degrees is 90 degrees


How do you show 30 percent on a pie chart?

A segcot whose angular measure (at the centre) is 360*30/100 = 108 degrees.


What measurement unit would you use to measure the length of a television show?

Time


How would you show 25 percent on a 10 times 10 grid?

On a grid containing 100 squares, 25 percent of the grid would be equivalent to shading in 25 squares.


What do you measure the mass of a coin in?

Usually you would weigh it, on a device that is calibrated to show mass.


How would you calculate the angle to show twenty percent in a circle graph?

0.20 x 180


How would you calculate the angle to show twenty percent on a circle graph?

Multiply the percentage by 3.6


Which show 70.8 percent percent as a decimal?

70.8 percent percent as a decimal is 0.708.


What are the release dates for The Abbott and Costello Show - 1952 Efficiency Experts 2-12?

The Abbott and Costello Show - 1952 Efficiency Experts 2-12 was released on: USA: 1953