answersLogoWhite

0

'http://wiki.answers.com/Q/If_breaker_CT_ratio_8001_when_current_of_any_phase_crossed_800_ampere_what_would_happen'

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What happen when a fuse wire of 100 ampere is used when a circuit at home draws a maximum current of 20 ampere?

The fuse or breaker should be no bigger than specified for the wiring and devices on the circuit. Your nominal current draw may be 20 amps, but a short circuit would cause maximum current to flow which in this case would be 100 amps until the fuse blew.


How does a circuit breaker trip and what causes it to do so?

A circuit breaker trips when there is an overload of electrical current flowing through it. This can happen when too many devices are plugged into the circuit or if there is a short circuit. When the current exceeds the breaker's capacity, it automatically shuts off to prevent overheating and potential fires.


When did Energy Breaker happen?

Energy Breaker happened in 1996.


When did Phantom Breaker happen?

Phantom Breaker happened in 2011.


When did Nano Breaker happen?

Nano Breaker happened in 2005.


What will happen if phase is directly connected to ground?

Assuming a circuit breaker is also installed, then you will have a phase-to-ground fault, or a dead short. This will cause the current draw to spike and extreme heat to be created, which will hopefully trip the breaker, which will stop the current flow. If no breaker or fuse is used, then the wires will eventually catch fire from the extreme heat.


When did Block Breaker Deluxe happen?

Block Breaker Deluxe happened in 2004.


What usually happens at consumer end when the current carrying capacity of transformer is exceeded?

What should happen is that the circuit-breaker should trip to cut off the current before the transformer becomes damaged by overheating.


What will happen to electrical devices if overloaded?

An overload condition is demanding more current than can be supplied. This could trip a breaker, blow a fuse or possibly destroy a device that is drawing too much current.


What happen when 220v dc is applied to a 220v ac single phase transformer?

The current would rise until it blows the fuse or breaker and that would produce an arc as the transformer's inductance tries to maintain the current.


Why does the AC keep tripping the breaker?

The AC may be tripping the breaker due to an overload of electrical current or a short circuit in the system. This can happen if the AC unit is drawing more power than the breaker can handle, or if there is a fault in the wiring or components of the AC unit. It is important to have a professional inspect and repair the AC to prevent further issues.


What do you think would happen if you put a 3A fuse in a plug used for kettle?

I know what would happen. The three amp fuse would blow. Any device that is plugged into a receptacle with out having sufficient resistance to limit the current flow will dead short the circuit and cause the breaker that feeds the circuit to trip. In this case the fuse being of a lower rating that the feed breaker the fuse will blow without tripping the receptacle's feed breaker.