the answer is 1..
either 1 or 3 not sure. its deffinatly not 2 or 4
its deffinatly 1 XD
Here it is the current sampler and it is connected in series. while the voltage mixer connected in series.
Because it one of the household appliances were to "go out" then all the household appliances would "go out" as well.
To measure the current in the circuit an ammeter is used and it is connected in series
a voltage source has very less(negligible)resistance.thus is considered as a short.if connected in parallel to a resistor will draw all the current acting as a short.thus is always connected in series of a resistor.where as a current source has tremendous resistance(infinity).thus if connected in series will be conidered as an open branch and no current will flow through it other than the source current.
1.In series connection the total resistance is equal the total number of resistor that was connected in series 2.the current is constant in a series connection 3.in a series connection total voltage is equal the number of of volt per cells
All home appliances are connected in parallel.
the answer is 1.. either 1 or 3 not sure. its deffinatly not 2 or 4 its deffinatly 1 XD
In a normal household configuration, the appliances are connected in parallel. This allows each of them to draw the amount of current they were designed to operate on. Unless you wired your own extension cord, you cannot connect them in series. Theoretically speaking (I hope you keep this theoretical), the loads in series increases the resistance of the circuit, which decreases the current through the circuit. None of the appliances would work properly. The more you connected, the less functional they become. There may be some other safety issues with their design compromised, but the appliances would not function properly and it is not possible to answer the question without some information about the appliances and power specs for each. Then it can be translated into a mathematical question.
Here it is the current sampler and it is connected in series. while the voltage mixer connected in series.
Current sources should not be connected in series. It's okay to connect them in parallel.
Because it one of the household appliances were to "go out" then all the household appliances would "go out" as well.
The number of batteries has only an effect on the amount of current when they are equivalent and connected in parallel. The amount of current that can flow from a group of batteries connected in series is limited to the current provided by the battery that produces the lowest current flow in the string.
To measure the current in the circuit an ammeter is used and it is connected in series
It's connected in series with the load.
Because it measures current.
No. By Kirchoff's Current Law, components in series all see the same current.
When battery cells are connected in series and a conducting circuit is connected between the terminals of the string, the current out of the positive terminal of each cell and the current into the negative terminal of each cell are all the same number.