lead
ONE low pass(RC) circuit gives 60 degrees phase shift
phase shift in integrator is 180 degrees and phase shift in differentiator is 0 degrees
The RC circuit can reduce the phase shift between the voltage and current in the power line. The phase shift is caused by the inductance of the motor. The phase shift between the voltage and current in the power line causes problems due to the presence of so called imaginary current or power that does no work but must be supplied by the power source.
180 degree phase shift
In the common emitter amplifier, an increase of base-emitter current causes a larger increase of collector emitter current. This means that, as the base voltage increases, the collector voltage decreases. This is a 180 degree phase shift.
Generation and detection of QPSK is complex.
ONE low pass(RC) circuit gives 60 degrees phase shift
The R-C oscillator is also called a phase shift oscillator because the R-C filter creates a phase shift from input to output. The feedback portion of the oscillator (an amplifier) then serves to pump energy back into the filter.
1AnswerA coherent detector uses the knowledge of the phase of the carrier wave to demoduleate the signal.it's simply a product device , which multiply the AM signal by a sinusoidal signal having the same carrier frequency , followed by a low pass filter ( LPF). The product will shift the AM signal to 0 Hz and double carrier frequency , and the LPF will eliminate the later component.2ANSWER:Coherent detectioninCoherent detectionrequires carrier phase recovery at the receiver and hence, circuits to perform phase estimation.Sources of carrier-phase mismatch at the receiver:inPropagationtalking causes carrier-phase offset in the received signal.inThe oscillators at the receiver which generate the carrier signal, are not usually phased locked to the transmitted carrier.coherent detection: Huge need for a reference in phase with the received carrierinLess complexity compared to incoherent detection at the price of higher error rate.Coherent ( synchronous ) detection: in coherent detection , the local carrier generated at the receiver in phase locked with the carrier at transmitter .Non coherent ( envelope ) detection : this type of detection does not need receiver carrier to be phase locked with transmitter carrier
A similar all-pass filter can be implemented by interchanging the position of the resistor and capacitor, which turns the high-pass filter into a low-pass filter. The result is a phase shifter with the same quadrature frequency but a 180 degree shift at high frequencies and no shift at low frequencies. In other words, the transfer function is negated, and so it has the same pole at -1/RC and reflected zero at 1/RC. Again, the phase shift of the all-pass filter is double the phase shift of the first-order filter at its non-inverting input.
The phase-shift oscillator gets its name from the phase-shift network used in its design, which introduces a phase shift in the feedback path of the circuit. This phase shift is necessary for maintaining oscillations in the circuit.
In a low pass filter, higher frequency components are attenuated more than lower frequency components. This results in a phase shift for the different frequency components, causing a difference in the phase between sine waves of different frequencies. This phase shift occurs because the filter delays higher frequency signals more than lower frequency signals.
phase shift in integrator is 180 degrees and phase shift in differentiator is 0 degrees
There is no phase shift.
The phase constant formula used to calculate the phase shift in a wave is 2/ d, where is the phase shift, is the wavelength of the wave, and d is the distance traveled by the wave.
differential phase-shift keying (′dif·ə′ren·chəl ′fāz ′shift ′kē·iŋ) (communications) Form of phase-shift keying in which the reference phase for a given keying interval is the phase of the signal during the preceding keying interval. Also known as differentially coherent phase-shift keying.Above retrieved from Answers.comViper1
The RC circuit can reduce the phase shift between the voltage and current in the power line. The phase shift is caused by the inductance of the motor. The phase shift between the voltage and current in the power line causes problems due to the presence of so called imaginary current or power that does no work but must be supplied by the power source.