answersLogoWhite

0

Are you talking about delaying the release of a relay? or actually slowing down the mechanism so it doesn't "Click". You'll NEVER get rid of the click, the inside of that consists of a metal arm attached to a spring. When current is applied, an electromagnet pulls the arm toward it and completes the circuit, it snaps because this happens very quickly. When the current is removed the spring snaps it back into its original place.

If you want to slow down the release, put a capacitor and resistor in front of it. The capacitor stores the charge, while the resistor limits how fast it discharges. The actually capacitor values and resistor values will vary with how much current needs to be applied to keep the relay closed, and the length of time you want to keep it that way.

(+)-------[Capacitor]-----[Resistor]------<Your Relay>--------(-)

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Lincoln town car relay schematic?

Hi, Relays generally have the schematic printed on them. Peace, crigby


2002 Chevy Malibu AC wiring schematic?

exactly where is the flasher relay


How do you get to the flasher relay on a 2000 Lincoln Town Car?

Relays in modern vehicles are located in one of two fuse/distribution boxes. Each box will have a schematic within the lid. Though, fast or slow blinkers are often caused by bulb elements going bad and not caused by the relay.


What is meant by 1TR Air conditioner?

If you are talking about the schematic wiring diagram it is Timer Relay#1.


Fuel pump wont start 95 jeep?

try the fuel pump relay in the engine bay. check wiring schematic for locations. swap with a/c relay or other same style relay to rule out a bad relay.


Where can I find the wiring schematic for a 1988 F150 305 starter soleniod?

a soleniod is just one item in a schematic its like a big relay if it needs to be replace its like 8 bucks, if you want the schematic for the whole starter system its basically battery+ to soleniod to starter to battery-


What food group has most slow releasing energy?

Vegetables


How do you know if AC relay is bad?

Turn on ac and watch clutch on front of ac compressor. If clutch doesn't engage then AC relay is bad. Or you can follow the schematic on the side of the relay and use a volt meter to test it.


Where is the main relay on a 2002 Mazda Protege?

The main relay is in the fuse panel located under the hood on the driver's (left) side. Original equipment relay is green. Schematic decal is on the inside of the fuse box cover.


Where can you find a free wiring schematic for the fuel pump and relay for 1991 s-10 4x4 4.3 v6?

At a Chevy dealer


How do you wire a 12 volt automotive relay?

there should be a diagram on the side of the relay with the pin numbers and some symbols. the pins that are on the coil or control side can be wired power and ground. this generally goes through a switch. the load side has a small gate looking symbol these can be wired power and ground either way and this is the side that you connect to whatever you are powering on. make sure to use a fuse on this circuit on the power lead.


Where is the flasher relay on 1995 camaro?

The flasher relay is located in the end of the dash on the driver's side by the main fuse block. Behind the panel is a bank of fuses and relays. On the inside of the cover is a schematic of the bank of fuses and relays.