If you are given a graph of the signal. Calculate the period, T, which length of time for one cycle.
The frequency is f = 1/T (Hz)
For example. T = 20 ms, f = 1/(20 ms) = 50 Hz.
If you are given an equation, in the form of:
v(t) = Vm cos (ωt + ϴ)
The frequency is ω (rad/s)
For example v(t) = 120 V cos ((314 rad / s) t + 0)
The frequency is 314 rad/s = 50 Hz.
to shift the frequency of information signal ,at the frequency domain to a higher frequency ...so the information can be transmitted to the receiver.
repetition rate of signal
The frequency domain of a voice signal is normally continuous because voice is a nonperiodic signal.
A low pass signal whose bandwidth is much smaller than its center frequency, such as an AM signal. It is a a signal with its spectrum concentrated around zero frequency.
The analog signal is converted to discrete signal. Even after the conversion, the frequency of the actual signal still remains the same. If the frequency of the discrete signal is different from the analog signal, the reconstructed signal would be different again. This is not what we expect. So base spectrum for similar signals have same frequencies, whether they are discrete or analog. Why do the repetitions occur? The original analog signal is multiplied with a dirac pattern. The base frequency is then shifted to the places, where diracs are available. So long the diracs keep repeating, the base frequency do repeats. Hope you are convinced with my answer
Amplitude of the (high frequency) Carrier signal is varied with respect to low frequency of message signal is called amplitude modulation. Frequency of the carrier signal is varied with respect to low frequency of message signal is called frequency modulation.
the low frequency signal which is nothing but the message signalNeither. The envelope will be that of the difference beat frequency. To get the envelope to follow the low frequency input signal you need to mix (multiply) the two signals, not add them.
Mix it with a local oscillator whose frequency is (the IF frequency) away from the frequency of the FM signal you're interested in.
to shift the frequency of information signal ,at the frequency domain to a higher frequency ...so the information can be transmitted to the receiver.
The zero phase frequency is the frequency at which the phase of the input signal and the output signal match.
when the frequency is low , energy will be obviously low. To increase the energy of the signal we need to increase the frequency. This is achieved by multiplying the message signal with the carrier signal (with high frequency).
If you sample at more than the Nyquist frequency (one half the signal frequency) you introduce an aliasing distortion, seen as sub harmonics.
modulating signal is the message to be carried by the carrier signal.
frequency meter is used to measure the frequency of unknown frequency signal.
repetition rate of signal
True.
There is no frequency of mono. Mono is a one channel signal, stereo is a two channel signal.