A 30 amp breaker is typically a larger, double-pole circuit breaker found in the electrical panel. It often has a plastic housing, usually colored black or gray, and features a toggle switch for easy on/off operation. The breaker is designed to accommodate 10 or 8 gauge wire, depending on the application, and usually has a label indicating its amperage rating. The terminals for the wires are located on the back or sides of the breaker.
Depends on the wire size you are using. If the generator breaker is a 30 amp then install a 30 amp breaker.
You have a double pole breaker for 240Volt supply. The maximum current is 15 amp.
Use a 30 amp breaker.
Not unless the wire going to the refrigerator outlet is AWG 10/2. If it is wired with 12/2 wire then you must use a 20 amp breaker. Using a 30 amp breaker is dangerous and a fire hazard.
A 30 amp breaker run 75 feet would require you use AWG #10 wire. But, an oven normally pulls more that 30 amps and I would not use #10 wire on a 30 amp breaker for an oven. Normally any newer oven is wired with AWG #6 gauge wire on a 50 amp circuit breaker so the breaker will not trip during heavy use of the oven. Some older ovens could use a #8 wire on a 40 amp breaker.
Replace the 30 Amp Breaker with a 15 Amp breaker.
Yes, a 30 amp breaker is a 30 amp breaker. It must however be able to fit the box it is installed in.
The recommended amperage for a 30 amp RV breaker is 30 amps.
The maximum amperage capacity of a 30 amp breaker is 30 amps.
If it is a 30 amp breaker then it is a 240 volt outlet.
Depends on the wire size you are using. If the generator breaker is a 30 amp then install a 30 amp breaker.
The appropriate double pole 30 amp breaker to use for a dryer installation is a 30 amp double pole circuit breaker.
The maximum amperage capacity of a 30 amp circuit breaker is 30 amps.
The recommended amperage for a breaker to use with a 30 amp dryer is 30 amps.
The maximum amperage capacity of a 30 amp breaker box is 30 amps.
The maximum current rating for a 30 amp circuit breaker is 30 amps.
For a 30 amp breaker, you will need a wire that is at least 10 gauge in size.