answersLogoWhite

0


Best Answer

it is a mechanical device whereby signal will move a motor shaft degrees

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What are the Features of stepper motor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Who invented the stepper motor?

In 1920,English engineer Walker invented the frist stepper motor which was a switched reluctance stepper motor.


Where is the Stepper motor for a 2004 Chevy impala located?

The stepper motor is located in the instrument cluster. The stepper motor is what turns the needles in all the gauges.


where can i buy a stepper motor driver online?

You could purchase a new stepper motor driver at a Home Depot. They offer new stepper motor drivers at great prices and the new stepper motor drivers are very durable.


How stepper motor?

A stepper motor is a type of electric motor that is brushless. The "question" isn't actually a question, so I'm not sure what else you would like to know about stepper motors.


What motor is used in watches?

stepper motor


Is a stepper motor with feedback loop a servo motor?

No, stepper and servo motor are by mechanical design two different types of motors.


Is a stepper motor easier to maintain than a normal ac motor?

A stepper motor is more easier to maintain than a normal ac motor. Ac motor is a seal motor under pressure. A stepper can easliy be open and the interwheels can be fixed and cleaned.


Where can i buy a bipolar stepper motor online?

YOu can go to the following website to buy a bipolar stepper motor online and for great prices http://www.anaheimautomation.com/products/stepper/stepper-motors-list.php?cID=19


What type of motor is used in refrigerator?

stepper motor


What is the type of motor used in hard disk drive?

stepper motor No. it is not a stepper. It is a Brushless DC (BLDC) motor. See related link for more information on this motor.


6 wire unipolar stepper motor pin connection?

tel me the connections of 6wire stepper motor with 8051 microcontroller


Why you use the call delay in case of interfacing of 8085 and stepper motor?

You need to introduce a delay after changing a driver output line for a stepper motor because the stepper motor requires finite time to respond to the command to step. Hundreds, if not thousands, of instructions can be executed while the stepper motor completes its step.