The advantage of this circuit is that there is very little current taken if there is no signal input
"What is class AB push pull amplifier and give its circuit and description .?"
To bias the transistors at 0.7 Volts.
When we get amplifier output current for 180 degrees of input. then it's called B class amplifier. In a push pull class B amplifier one of the two power transistors or other amplifying elements handles the positive half of the waveform and the other element handles the negative half of the waveform. In practice, push pull audio amplifiers are usually class AB; each power transistor handles slightly more than 180 degrees of input. This minimizes distortion (crossover distortion) when one of the two transistors ceases output and the other takes over.
Sound amplification. Servo control systems.
advantage of inverting amplifier
"What is class AB push pull amplifier and give its circuit and description .?"
nthing
No, a push-pull amplifier can be built class A, class AB, class B, or class C depending on application.class A push-pull is used for low power audio usuallyclass AB push-pull is used for high power audio usuallyclass B and class C push-pull is used for very high power radio usually (B is typical for AM and C is typical for FM)
Odd harmonics are theoretically the only harmonics that are produced by a push-pull amplifier, and even the level of odd harmonics should be very low.
To bias the transistors at 0.7 Volts.
Yes... Obviously.. Since technology is getting advance and you can even search it on wikipedia...
When we get amplifier output current for 180 degrees of input. then it's called B class amplifier. In a push pull class B amplifier one of the two power transistors or other amplifying elements handles the positive half of the waveform and the other element handles the negative half of the waveform. In practice, push pull audio amplifiers are usually class AB; each power transistor handles slightly more than 180 degrees of input. This minimizes distortion (crossover distortion) when one of the two transistors ceases output and the other takes over.
Sound amplification. Servo control systems.
Sound amplification. Servo control systems.
Because two amplifiers are used to accomplish class B power amplifier. One is used to push the current and the other one is used to pull the current. These two amplifiers are almost same but one is connector supplied and the other one is emitter supplied.
The main advantage is lower power dissipation as the amplifier is not conducting half the time, however the resulting disadvantage is that it is nonlinear unless the more complex push-pull amplifier design is used (requiring about twice as many components).
The Class B amplifier is a push pull amplifier with 78.5% efficiency. The high efficiency is due to the absence of power consumption during idle time which simultaneously increases the efficiency.