Air and hydrogen gas can be pumped through
When two generators are to be run in parallel, one generator is first started and some load is given. Then second generator is brought in parallel with the running generator (subject few conditions, like voltage, frequency, phase angle). First generator which is running is known as running generator, the second generator which gets connected is known as incoming generator
It works with two reactor coils for excitation of the field reactor coil , which in turn provides current to the field. The two reactor coils are connected in shunt and series with the output of the generator stator or armature ( from where load is connected).
There is no such thing as a two phase load any more. Any two legs from a three phase system are classed as single phase. If this single phase load is connected across the generator it will induce an imbalance in the output voltages of the generator. This is one reason that single phase loads on a three phase generator should be shifted around to find the best possible balance.
To answer this question the voltage and amperage of the unit must be stated. Once this is given the generator size can be calculated.
when the current is passing through the winding then it is called "Excitation". Types of excitation (1)seperately excited generator. (2)self excited generator. self generator is classified into 3 types. 1.shunt generator. 2.series generator. 3.compound generator. compoud generator is again classified into 2 types. 1.short shunt generator. 2.long shunt generator.
Air and hydrogen gas can be pumped through
A wind turbine generator can be cooled using an air cooling system that utilizes fans or ventilation to dissipate heat. Alternatively, a liquid cooling system can be used, where a coolant such as water or oil is circulated around the generator to absorb and transfer heat away from the components.
Mechanical (generator) and Chemical (battery)
Air and hydrogen gas can be pumped through
RADITOR * Small generators either air cooled or water cooled 2 stroke. Autos are mainly 4 stroke and the majority watercooled.
There are typically two ways to turn a generator: manually by hand or through an external power source such as an engine or motor, which in turn spins the generator shaft to produce electricity.
under the stand for the generator where it bolts to the engine
This is not dependable
Increase the rotational speed of the generator by using a more powerful prime mover like a larger engine or turbine. Increase the strength of the magnetic field within the generator by adding more coils of wire or using stronger magnets.
Air cooled & Liquid cooled
There are an unlimited number of ways you could make a mini generator. You could use fan power for example.
There are two types me dc generator 1 separately excited dc generator 2 self excited dc generator