brush friction, poor ventillation, excessive sparking caused by high voltage
Ac motor have slip ring, to remove the slip ring,connected to the commutator its a dc motor.
To state it simply, a DC brushless motor is not a DC motor. It is an AC motor with an inverter (or electronic commutator) on the front end to make the AC, so you can use a DC input.
It is the process of conversion of generated ac voltage into the armature of a dc generator to dc voltage at the terminal of the dc generator by use of pair of brushes and commutator. OR It is the process of conversion of given dc voltage at the terminal of the dc motor to ac voltage in the armature windings in a dc motor by use of pair of brushes and commutator.
It depends entirely on the motor design. The only universal disadvantage of a DC motor (vs. an AC motor) is the need for a DC power supply (DC power is more difficult to transmit efficiently over long distances, hence the use of AC for typical power grids). Typical brushed DC motors (the cheapest and hence one of the most common type of DC motor) tend to wear out eventually due to friction and draw MUCH higher current when stalled than when turning, which can cause overheating. They are also typically heavier than AC motors with similar specs. Of course all of these problems can be eliminated by using a (slightly more complex) brush-less motor design.
a motor Will do work by consuming power a generator is just the opposite
The commutator is part of the armature on a DC motor and this assembly is the rotating element of a motor.
Commutator is a device in a motor through which supply is fed.
its commutator..which converts ac produced by and motor to pulsating dc ... more the commutator divide more accurate dc..means less pulse in dc
Found one DC motor having small sparking,but the commutator is light and dark bar pattern.commutator is round. We 500kw dC motor operted at 500rpm with 480Amp's .The DC motor full load current is 1050Amp's. Why the commutator had small spaerking.
Ac motor have slip ring, to remove the slip ring,connected to the commutator its a dc motor.
To state it simply, a DC brushless motor is not a DC motor. It is an AC motor with an inverter (or electronic commutator) on the front end to make the AC, so you can use a DC input.
commutator
Commutator and brushes.
commutator
It is the process of conversion of generated ac voltage into the armature of a dc generator to dc voltage at the terminal of the dc generator by use of pair of brushes and commutator. OR It is the process of conversion of given dc voltage at the terminal of the dc motor to ac voltage in the armature windings in a dc motor by use of pair of brushes and commutator.
A commutator less DC motor is nothing but a self controlled synchronous motor is being widely used in industries for high speed and large capacity.
The commutator is a rotating switch, which reverse the polarity of the generated voltage every half-cycle. So it acts to rectify the output voltage.