2 inch Rigid or IMC conduit if it's on a structure. 2 inch schedule 80 PVC conduit if it's on a wood pole.
As a service entrance wire you need AWG # 3/0 gauge copper.
sounds like you have a 100 amp service to your home.. that will need to be upgraded to a 200 amp service.. you shouldn't have any problems after upgrade..
Yes, the wire size has to be increased. The existing 100 amp service will now probably have a #3 conductor with an insulation factor of 75 or 90 degrees C which is rated for 100 and 105 amps respectively. Increasing to a 150 amp service will use a #1/0 wire size. If you are thinking of an upgrade, skip the 150 amp service and go to a 200 amp panel. New homes are installing 200 amp 42 circuit panels. The extra cost is only reflected in the materials as the labour costs will be the same regardless whether a 150 amp or a 200 amp panel is installed. The wire size for a 200 amp panel is #3/0. With an insulation factor of 75 or 90 degrees C the rating is 200 or 210 amps respectively.
A 200 amp service using a uffer ground will need a #3 bare copper wire. The bare copper wire is to be not less than 20 feet in length. It also has to be within 2" of the concrete foundation footing that is in direct contact with the earth. The depth can not be less than 2 feet below finished grade.
Depends on the size of the service. 100 amp service will require 3 gauge, 150 amp service will require 1/0 gauge, and 200 amp service will require 3/0 gauge.
The recommended conduit size for a 200 amp service is typically 2 inches in diameter.
200 ft 1200ft
Typically, EMT (Electrical Metallic Tubing) or RMC (Rigid Metal Conduit) is used for mast electrical service installations. These conduits provide protection for the electrical wiring from damage and are suitable for outdoor applications. The choice between EMT and RMC depends on factors such as the environment, code requirements, and specific installation needs.
A circle with an area of 200 acres has a diameter of: 3,331 feet.
The circumference is 200 times 3.14159 = 628.32 The circumference C is pi times diameter d. pi = 3.14159
Perimeter = pi*diameter so 200*pi = 628.32 metres.
The volume of a pipe that is 10mm diameter and 200 meters long is: 0.015708 m3
100. The radius is 1/2 of the diameter.
Its diameter will be: 2*100 = 200 miles
200 miles
200
About 40 panels, if the panel produces around 5a ea 5amp /200 =40. But don't expect it to be constant due to sun Ducking in and out of the clouds and cloudy and rainy days.