DC or Direct Current. The current is no alternating.
A voltmeter has greater accuracy when measuring direct current. This kind of current is constant unlike alternating current which has constant fluctuations.
No. A constant DC current of sufficient magnitude induces smoke in a transformer.
the current will increase because of a lower level of resistance , hence more current will flow- easily
V = IR Where, V = voltage I = current R = resistance Thus if resistance is increased with constant voltage current will decrease
An inductor is a device that resists a change in current. The equation is di/dt = v/L. This means that inductors are current sources, and given a sufficiently large inductor, in comparision to the circuit, it is a constant current source.
The output impedance is z= V/I, the ratio of the constant voltage and the constant current source.
What is considered "constant current"
In DC or direct current, the flux is constant. AC or alternating current is variable.
A voltmeter has greater accuracy when measuring direct current. This kind of current is constant unlike alternating current which has constant fluctuations.
The amount of current (amps) is controlled by the user. It's done with a variable resistor. Another thing to note is whether you are welding constant current or constant voltage. If you are welding constant current, the voltage will vary and a set Amp measure will remain constant. With constant voltage, the current will vary and that's determined by the resistance. Constant voltage should be an easier set up. I'm not 100% sure but most stick welding is constant current, which is why increasing the arc length produces more heat, because more arc length should increase the resistance, which would cause the welding machine to increase voltage to keep the current constant.
In one direction - or constant - is called direct current. The other sort is called alternating current.
Ohm's Law: voltage = current * resistance. If resistance is a constant, then voltage is directly proportional to current.
I = E/R If resistance is constant, then current is directly proportional to voltage. Double the voltage ===> the current will also double.
Since the Emf(voltage) being supplied to circuit is constant then so is the current in series circuit.In parallel circuits the current is then divided depending on the resistors.but for both circuits the sum of the current in= current outAnswerIt's not necessarily 'constant', but it will be the samecurrent.
Inversely. As resistance increases, current dereases; given that the applied voltage is constant.
No. A constant DC current of sufficient magnitude induces smoke in a transformer.
If resistance is halved while voltage remains constant, the current will double.