An XNOR gate is a logic gate performing a Boolean logic XNOR operation, also known as an equivalence gate.
It depends. XNOR is the inverse of XOR. If the N(ot) part is on the inputs, then they are equivalent. If the N(ot) part is on the output, then they are not.
4
THE MAIN ADVANTAGE OF THE UNIVERSAL LOGIC GATES IS THAT IT CAN BE USED TO MADE ANT KIND OF LOGIC GATE .......BY USING IT . NAND AND NOR ARE CALLED AS UNIVERSAL GATES ARE USED TO MAKE ANY GAATES AS OR ,AND, XNOR,NOT. logic gates are used in many everyday electronic devices such as tv's, computers and telephones.
A: A gate any gate make logical decisions to pass or not to pass a true or a false. Since a gate must have two inputs to be called a gate for an OR gate any true '1' signal will pass trough which is opposite to an AND where any false '0' will pass trough
For two input AND gate it is 7408for three input AND gate it is 7411
xor and xnor gates are derived from not gate
7404
XNOR gate is called coincidence gate
Either XOR or XNOR can be used, but the output will be inverted on the XNOR.
(a'b+b'a)'
All other logic gates can be made using XOR and XNOR, but to get NOT, you need to do (input) XOR 1 or (input) XNOR 0, but with NAND, you don't need 1: (input) NAND (input).
A XNOR gate for comparing 2 inputs
XNOR gate is a two input gate.And if two inputs are the same they are Known as the Coincidence gate.Electronics can be very interesting if you understand the fundamentals of it.
If you take a look at the truth table of XNOR (for example, check the Wikipedia article on XNOR), you'll see that the output is true (or 1) exactly when both inputs are the same.
A, B and C are inputs, Q is output.A B C Q0 0 0 10 0 1 00 1 0 00 1 1 11 0 0 01 0 1 11 1 0 11 1 1 0*update*Although the Logism software shows the 3 input XNOR gate output 1 when all 3 are 1, perhaps there is a mistake, and 3 input of 1,1,1 in an XNOR gateoutputs 0. There is a good reason why. In an XOR gate, an even amount of 1 or 0 input will output a 0, and an odd input of 1 (ie: 1, 1, 1) will output a 1. The truth tablefor an XOR gate with 1, 1, 1 input is an output of 1. An XNOR gate will output the opposite of an XOR gate, thus XNOR input of1, 1, 1 should output 0.
the easiest way to make an xnor gate is with a 7486 (or equivalent) integrated circuit, a quad xor gate. connect the output of one gate to one in put of another gate. connect the other input of the second gate to Vcc. the second xor gate will then act as an inverter.
XNOR gate is used to detect even or odd 1s parity bit in circuits. It can also be used in Heat exchanger tank. When water level is in range it shows 0 output. when its level goes up or down,output shows 1 and alarm sounds.