answersLogoWhite

0

used to detect the microwave signal

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What is the function of diode detector?

the function of a diode detector is to detect stuff


What is function of waveguide in microwave devices?

It replaces a coax cable, which won't work at those frequencies.


What is the function of detector in UV spectrophotometer?

Detector converts optical signal to electric signal


What is the dominant mode in rectangular waveguide?

Rectangular Waveguide - TE10; (TM11 in case of TM waves) Circular Waveguide - TE11;


What is the function of light detector circuit?

a: its function is to detect a change of light withing its perimeter


What are the steps involved in hardwired smoke detector installation?

Turn off power to the area where the smoke detector will be installed. Remove the old smoke detector, if applicable. Connect the new smoke detector to the existing wiring. Mount the smoke detector on the ceiling or wall using screws. Restore power and test the smoke detector to ensure it is functioning properly.


Why must the air inside a waveguide be dehumidified?

Moisture in the air in a waveguide can scatter the microwave energy the waveguide is designed to transport. This translates into signal loss or attenuation. The VSWR drops, and that is not a good thing.


What should I do if my smoke detector is indicating a low battery?

If your smoke detector is indicating a low battery, you should replace the battery immediately to ensure that the detector continues to function properly and provide early warning in case of a fire.


What are the Differences between horn antenna and waveguide?

waveguide is a metal pipe that contains and guides microwaves from place to place in a microwave system (e.g. oscillators, amplifiers, mixers, modulators, filters, antennas)horn antenna has a waveguide connected at its focus, in transmit mode the waveguide feeds the horn which then emits a microwave beam, in receive mode the horn collects a microwave beam and concentrates it int the waveguide


What is the purpose of a discriminator in an FM broadcast receiver?

The discriminator, and the ratio detector, perform the same function in an f.m. receiver as the detector does in an a.m. receiver, i.e. it recovers the modulation.


The waves which cannot be transmitted in waveguide are?

The waves that cannot be transmitted in a waveguide are those that have a wavelength longer than the cutoff wavelength of the waveguide. These waves are unable to propagate efficiently within the waveguide due to the cutoff phenomenon which restricts their transmission.


What should I do if my smoke detector is beeping due to a low battery?

If your smoke detector is beeping due to a low battery, you should replace the battery immediately to ensure the detector continues to function properly and keep your home safe from potential fires.