0
When low inductive currents, such as magnetiing current of transformer, shunt reactors are interrupted by breaker, there is rapid deionization of contact space and may cause the current to be interrupted before its neutral zero. This phenomena is callad current chopping
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What is meant by wattless current?
Current flowing through an ac circuit in which power consumed is zero is called wattless current.
What is meant by 1.55 in busbar current calculation?
Busbar current rating for 1 square inch is 1000a.
If pressure is constant and current increases the resistance?
I assume you meant pressure to voltage. The resistance of a conductor is directly proportional to the temperature of the conductor. If the temperature of the conductor increases due to increased current, then the resistance tend to increase too.
What is meant by lagging and leading circuit?
The terms, 'lagging' and 'leading', describe the relationship between a circuit's load current and supply voltage. They describe whether the load current waveform is leading or lagging the supply voltage -always the current, never the voltage. Inductive loads always cause the current to lag the supply voltage, whereas capacitive loads always cause the current to lead the supply voltage.
What is meant by the term fusing factor?
Fusing factor is the ratio of a fuse's minimum fusing current (the smallest current that will cause the fuse to melt) and the nominal rated current (usually the number in Amps marked on the fuse body).
What are chopping boards used for?
Chopping
A sentence with the word chopping?
the chef is chopping tomato
What is meant by the term resistance?
What is meant by the term resistivity?
When was Chopping Machine created?
Chopping Machine was created in 1995.
When was Richard Chopping born?
Richard Chopping was born in 1917.
When did Richard Chopping die?
Richard Chopping died in 2008.
What are wooden glass and plastic chopping boards used for?
chopping
What is meant by the term fusing current?
Fusing current for a wire is the current at which the wire will act like a fuse (melt).
What is the tray you use in chopping called?
Chopping board/ cutting board
What is the duration of Chopping Mall?
The duration of Chopping Mall is 1.28 hours.
What is the duration of The Chopping Block?
The duration of The Chopping Block is 3600.0 seconds.
What is the meaning of chopping cotton?
Chopping cotton isn't really chopping cotton. When you are "chopping cotton" you are chopping down weeds that are growing in the rows that the cotton is planted in. Johnson grass and stuff like that.
