PU stands for pickup. It is one of the many settings that are used while trying to set the right relay.
"PU" can stand for multiple things, depending on what part of "electrical engineering" you're interested in. In the power world (power generation, transmission, distribution) "PU" may stand for per unit, or pickup if related to protective equipment like relays.
The "pick up" of a relay is a setting at which the relay will begin to operate. Such as an overcurrent relay - if the pickup is set to 5A, when 5A is flowing through the relay, the relay will operate.
I think aux relay is part of relay
Earth fault relay and an over current relay Methods to energies an earth fault relay with simulation diagram?
Print Settings, Report Settings, and Screen Settings
no such relay.
location of ABS relay module for 04 2500HD pu
In the fuse/relay center under the hood.
I have a 93 c2500 pu and my tranny is acting up. It doesn't always want to shift outta first
The drl relay is located in the back of the glove compartment.
Follow the + battery cable should connect to the starter relay (solenoid)
this is the true song in chinese....................puka heyo karu! kesomanana kiyosiyo temonda!kese so tepatio komina pu-pu-pu-pu-pu-pu-pu-pu-pu-pu kaa kasiyo pu-pu pu-pu-pu-pu-pu-pu-pu-pu-pu-pu kaa kasiyo pu-pu-pu-pukaaa heyo karu kisiyosikiyo ke pa mon
feed to the CO relay had a short at the efi fuse in the main relay box. running a replacement wire with inline 15 amp fuse {solved} the problem. nothing like an ohm tester
There is not a relay in that system. The speed control is entegral to the engine control computer. To change these settings requires reprograming the computor.
The Pu Pu Chinese resteraunt is at 2060 Centre St, in West Roxbury, MA. Then there is the PU PU Hot Pot in Cambridge, England.
check fuse/relay then if not that idle air control valve 'throttle control sensor' map sensor' electronic control module' test them all.
PU 2.4L PU king cab XE 3.0L PU SE 2.4L PU short bed XE 2.4L PU XE 2.4L