answersLogoWhite

0

A switch that is controlled by other electrical components.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How can the power be controlled in a 3-way switch setup where the power is located at the switch?

In a 3-way switch setup where the power is located at the switch, the power can be controlled by connecting the power source to the common terminal of one switch and then connecting the other two terminals of the switch to the travelers of the second switch. This setup allows for the power to be controlled from either switch in the circuit.


What can current electricity be controlled by?

a switch


Why does the parking light stay on when you turn the car off?

because the lights are not controlled by the ignition switch; they are controlled by a separate light switch.


Where is the fuel shut off switch for a 1991 dodge shadow?

The fuel system does not have shut off switch. The system is computer controlled with relays.The fuel system does not have shut off switch. The system is computer controlled with relays.


What is the function of an outlet controlled by a switch?

An outlet controlled by a switch allows you to turn the power on or off to the outlet using the switch. This can be useful for controlling the flow of electricity to devices or appliances plugged into the outlet.


Where is the inertia switch on a 1996 Dodge Caravan?

The Dodge Caravan doesn't use an inertia switch. The fuel pump is controlled by a relay.The Dodge Caravan doesn't use an inertia switch. The fuel pump is controlled by a relay.


Does an outlet controlled by a light switch still pull energy when the light switch is off?

No.


Where is the kill switch on 93 Maxima?

It is controlled by the ignition key. It has no inertia switch if that is what you are asking about.


What is the purpose of the fin on a rocket?

Possibly to produce stability or a semi-controlled flight (?)


Plymouth inertia switch?

It doesn't have an inertia switch. The fuel system is computer controlled with relays.


Is there a safety shut off for fuel pump on a 1990 Buick Skylark?

The fuel pump is controlled by a relay. It does not have an inertia switch.The fuel pump is controlled by a relay. It does not have an inertia switch.


Where is the reset button for fuel pump on a 2000 Chrysler Sebring?

A Chrysler Sebring does not have a reset switch. The fuel system is computer controlled with relays.A Chrysler Sebring does not have a reset switch. The fuel system is computer controlled with relays.

Trending Questions
Electrical wire sheathing should not project more than about 1 inch into the Aplumbing line B floor joist C electrical panel D ground? Why potential difference is necessary to produce current in a circuit? What technology is an open protocol standard that allows switches to automatically bundle physical ports into a single logical link? Wave energy converter pelamis how much does it cost? What is the difference between a BCD to decimal decoder and a BCD to 7-segment decoder? How does increase in VAR cause increases in bearing damage caused by shaft vibration in the shaft connecting turbine to generator in a 210 MW turbine-generator set? How you increase current by keeping voltage constant? What are disadvantages of full adder using two half adder? Electricity and load shedding Questions and answers? How will you differentiate the diodes whether it is Zener or avalanche when you are given two diodes of rating 6.2 v and 24V? What do you admire most about Thomas Edison? What is the difference between Square d qo vs hom type breakers? What is locked rotor current? Is 14 wire gauge good for 1500 watts? What are the disadvantages of flip flops? Reconnect electric meter yourself? Will a 15 A circuit breaker trip if a 15 ohm toaster is turned on in a circuit that already has a 0.20 hp motor and three 100 W light bulbs and a 600 W electric iron? What is the need of extra high voltage transmission lines? Reason for using wire wound resistor in electronic circuit? How can a technician prevent burning the surroundings whil soldering in a tight area?