0
What else can I help you with?
What is the Difference between supply voltage and input voltage?
no difference...
What is impresses voltage?
It is another way of saying "Apply a voltage" or "supply (something) with a voltage"
What is meant by lagging and leading circuit?
The terms, 'lagging' and 'leading', describe the relationship between a circuit's load current and supply voltage. They describe whether the load current waveform is leading or lagging the supply voltage -always the current, never the voltage. Inductive loads always cause the current to lag the supply voltage, whereas capacitive loads always cause the current to lead the supply voltage.
What is open circuit characteristic?
The terminal voltage is equal to the supply voltage and there is zero current.
What is the maximum supply voltage for a 74LS08?
The maximum supply voltage per the data sheet is 5.25 volts. This is a common max for TTL type IC's.
How can you get 12volts supply from speaker?
You can not. Speakers do not supply a voltage they need a voltage to operate correctly.
How do you calculate The Percentage Voltage Drop?
The percentage voltage drop is calculated using the formula: [ \text{Percentage Voltage Drop} = \left( \frac{V_{drop}}{V_{supply}} \right) \times 100 ] where ( V_{drop} ) is the voltage drop across the load or conductor, and ( V_{supply} ) is the supply voltage. Measure the voltage at the load and subtract it from the supply voltage to find ( V_{drop} ). Then, apply the formula to express the voltage drop as a percentage of the supply voltage.
Do you add electrical supply voltage and induced voltage of a coil to get total voltage on the coil?
The induced voltage acts to oppose any change in current that is causing it. So, if the current is increasing, then the induced voltage will act in the opposite direction to the supply voltage; if the current is decreasing, then the induced voltage will act in the same direction as the supply voltage.
How many watts will be neede to supply 400 amp welder?
It depends on the supply voltage watts = current in amps times the supply voltage
What is the Difference between supply voltage and input voltage?
no difference...
What is impresses voltage?
It is another way of saying "Apply a voltage" or "supply (something) with a voltage"
What Intel chip powered the Busicom calculator?
45nm
What happens to supply voltage if additional resistance is connected in parallel circuit?
The supply voltage in a parallel circuit remains the same regardless of the number of additional resistors connected. The voltage across each resistor in a parallel circuit is the same as the supply voltage. Adding more resistors in parallel will increase the total current drawn from the supply.
How do you include 45nm technology parameter in tanner Eda tool schematic?
To include 45nm technology parameters in a Tanner EDA tool schematic, you need to ensure that you have the appropriate process design kit (PDK) for 45nm technology. Load the PDK into Tanner's tool environment, which will provide you with the necessary libraries and models. Then, create or modify your schematic using the components and models defined in the PDK, ensuring that you apply the correct design rules and parameters specific to the 45nm process. Finally, simulate your design to verify its functionality and performance against the 45nm specifications.
At what voltage should hair dryers be set?
The voltage for anything should match the supply voltage.
What is Supply voltage rejection ratio?
Supply Voltage Rejection Ratio (SVRR) is a measure of how well a circuit, typically an amplifier or regulator, can maintain its output stability despite variations in the supply voltage. It is defined as the ratio of the change in supply voltage to the resulting change in output voltage, often expressed in decibels (dB). A higher SVRR indicates better performance, as it means the output is less affected by fluctuations in the supply voltage, which is crucial for ensuring consistent operation in electronic systems.
When do you need to convert the voltage for appliances?
You need to convert the voltage if your appliance requires less voltage than you power supply. example: appliances is 110V and power supply is 220V.
