answersLogoWhite

0

A The term signify a range of frequency that are either excluded or included as a pass or no pass situation. The frequency are not set to a specific range it just depends when designing what is to be included or excluded for a particular circuit.

User Avatar

Wiki User

14y ago

What else can I help you with?

Continue Learning about Electrical Engineering

Definition of gang condenser in electronics?

In a radio receiver, a gang condenser is a type of air capacitor


Definition of recovery time of sensor?

This term is often used with electronics and engineering. By definition, the recovery time of a sensor is the time a sensor takes to return to a baseline value after an event.


Is low bandwidth signal has more power than high bandwidth signal?

no,because generally the lower frequency side existed for lower bandwidth,and higher frequency side existed higher bandwidth,so thus we can say that lower bandwidth has generally has lower power as compared to higher bandwidth.


What is relation between roll off factor bandwidth and bit rate?

The roll-off factor of a digital filter defines how much more bandwidth the filter occupies than that of an ideal "brick-wall" filter, whose bandwidth is the theoretical minimum Nyquist bandwidth. The Nyquist bandwidth is simply the symbol rate expressed in Hz: Nyquist Bandwidth (Hz) = Symbol Rate (Sym/s) However, a real-world filter will require more bandwidth, and the excess over the Nyquist bandwidth is expressed by the roll-off factor. Suppose a filter has a Nyquist bandwidth of 100 MHz but actually occupies 120 MHz; in this case its roll-off factor is 0.2, i.e. the excess bandwidth is 0.2 times the Nyquist bandwidth and the total filter pass-bandwidth is 1.2 times the Nyquist bandwidth.


What is the difference between transmission bandwidth and channel bandwidth?

The transmission bandwidth refers to the range of frequencies that are being transmitted from one point to another. The channel bandwidth on the other hand refers to the frequencies of a given channel.

Related Questions

What is the definition of audio electronics?

The definition of audio electronics is the part of science that is dealing with reproducing and recording devices through another device amplifiers.


What parameters determine bandwidth of coax cable?

The insulation and the resistance within the cable is of great importance. Whether the inner cable is one filament or several twisted together also is part of this. The composition of the alloy used is important. How long the stretch of cable is does influence bandwidth drastically. The electronics used is often very important. Electronics can be made to compensate for flaws in cheaper cables, hence giving you greater bandwidth.


Definition for latch on digital electronics?

latch is electronic circuit.....


What is the definition of electronics and where is it used?

it is the study of electrons and its electronic phenomenae.


BE Electronics and Instrumentation Engineering question bank?

in pcm system if the quantization levels are increased from 2 to 8, the relative bandwidth requirement will ?


What is a short definition for remote?

1. a device used to control electronics or 2. away from society


Definition of gang condenser in electronics?

In a radio receiver, a gang condenser is a type of air capacitor


Things begin with letter b use in technology?

Bandwidth is a technology word. It begins with the letter b.


What is the definition of electronics and communications engg?

'Defination' is not correct. The definition of electronic and communication engineering is engineering aimed at processing, sending and receiving data in understandable forms.


Does using electronics pollute the air?

This all depends on your definition of pollution. Yes! EMI (Electro Magnetic Interference). Electronics creates magnetism. Cell phones, and anything that transmits.


What does staggered tuning in electronics means?

It refers to the tuning a a multi-stage IF amplifier where successive stages are tuned to one side or the other of it's center frequency to create a wider bandwidth.


What is the definition of choke as it applies to electronics?

A choke in electronics is used for blocking the higher frequency known as AC. When this occurs it allows the lower frequency known as DC to pass through the electrical conductor.