A ct is a step up transformer where as a pt is a step down transformer because both are used for measurement and protection purpose . current is stepped down if the secondary windings are more so we can obviously say thar ct is step up transformer
Transformer Motors CT,PT Genrators these all are electrical devices
K=(voltmeter range*ammeter range*power factor)/wattmeter range
By Using CT and PT, The RMS Current, RMS Voltage, True Power are measured by using Sample and Hold Circuits and converts into ADC then using Microcontroller or Microprocessor to calculate the Real values.
high impedance circit provides a varistor unit which has stabilising resistor which ll protect the relay from being operating for maloperations like through fault, CT faults whereas this varistor unit is provided internally in an numerical relay where the CT of class 5P can be used.
difference between detector and diode
the same as the difference between ct and k
The difference in between Ohms and Ohms CT is that in Ohms CT it has CT at the end.
Multiplication factor can be derived from Meter CT, Meter PT, Connected CT and Connected PT values.
A CT is used to measure current, and is NOT referenced to ground, and has very low primary impedance. A PT is used to measure voltage, is referenced to ground, and has a much higher impedance (since it is referenced to ground).
CT=========current transformer PT=========potential transformer these are the instrumental transformers.
Either Bridgeport, Ct or Bethel, Ct
There is no time difference between Central European Time and Irish Summer Time.
The difference between 22 ct gold and 14 ct gold is that 22ct gold is 91.6 percent gold. 14 ct gold has 58.3 percent gold. The higher the number, the more pure gold is.
The difference between the PT Cruiser Touring Edition and the Limited Edition are related to the trim package. The Limited Edition has a different bumper, grill, and scalloping in the passenger compartment along with some extra electronics.
Kt is American and Ct is English both mean the same thing.
A current transformer pushes a ratio of primary current in the secondary. A potential transformer pushes a ratio of primary voltage in the secondary. Shorting a CT allows the full current the CT wants to push to flow. Shorting a PT makes it very difficult for the PT to produce rated voltage. To keep the voltage at rated value, the PT would have to push ~infinite secondary current.
Spokane is located in the Pacific Time zone (PT). It is one hour behind Mountain Time (MT), two hours behind Central Time (CT), and three hours behind Eastern Time (ET).