0
What else can I help you with?
What is the clearance between the front of a 480 V panel and a partiton?
The National Electrical Code (NEC) typically requires a minimum clearance of 3 feet between the front of a 480 V panel and any obstruction, such as a partition. This distance ensures safe access for maintenance and emergency situations. However, always consult local codes and regulations, as they may have specific requirements that differ from the NEC.
What is the minimum distance allowed between two joints in a high voltage cable of 66 KV?
the minimum distance between two cable joint 2 meter (refer IEC 60052-4)
What is the minimum age to attend a class for electrical installation training?
To be qualified for electrical installation training in the US, you must be at least 18 years or older.
What is the minimum size wire allowed for a parallel run?
The minimum size wire that can be paralleled together stated in the electrical code book is a #3 copper conductor.
What is the distance needed from an electrical panel to the edge of a roof?
There is no specific distance specified in the code book. The meter stack has to be on the outside of the building and some times this means bringing it through the eave end of the roof line. The connection point has to be 15 feet high as a minimum. The utility meter has to be at head height on the outside wall for the meter reader to see and read it. On the lower end of the meter stack is the electrical panel. As you can see the distances will change in every circumstance depending on where the electrical panel is placed. The electrical panel can not be placed any further in the building from the outside wall than ten feet.
What is meant by minimum electrical clearance?
The minimum electrical clearance is the minimum distance between electrical conductors with different potentials (voltage). This generaly determined by the maximum possible voltage differenge between the conductors. Dimensions larger then the minimum electrical clearance are OK, however smaller dimensions start to risk arc-over between your conductors.
What is the minimum percentage allowable for brake pads on a tcuv?
75%
What is minimum efficiency for gas fired forced air furnaces?
Currently the minimum allowable for sale is 80%.
What is the required distance specified by the electrical code for installing electrical wiring in relation to a gas line?
The electrical code typically requires a minimum distance of 12 inches between electrical wiring and a gas line to ensure safety and prevent potential hazards.
What is the minimum allowable brake accumulator pressure required for tow?
3000 PSI
What is the minimum allowable grade on a 4in sewer pipe?
1% pitch is min
The minimum distance between the declination station and such objects as power lines and electrical equipment is?
Power lines and electronic equipment: 150m
What was the minimum allowable width of bikinis at Bondi Beach in 1961?
Type your answer here..5 inches
What is the minimum distance a 13amp socket outlet can be wired to a shower cubicle in a bedroom?
The minimum distance a 13amp socket outlet can be wired to a shower cubicle in a bedroom is 3 meters horizontally from the outer boundary of the shower basin or tray. This is to comply with electrical safety regulations and reduce the risk of electrical hazards near water sources.
How far does separating plumbing pipes and electrical wiring?
Whether the pipes and wiring are chased or not. A minimum distance of 200mm is recommended. Making sure that the water pipes are always underneath the electrical wiring.
What is the minimum allowable interest rate on a promissory note between two private parties in the state of Florida?
Minimum interest upon promissory note in wisconsin Loo
What is the minimum allowed flash point for fuels on board naval vessels?
The minimum allowable flash point for all fuels on US naval vessels is 140oF (60oC)
