one will be ground the other 3 will be steps when each is powered indiviually
tel me the connections of 6wire stepper motor with 8051 microcontroller
The answser is White- black -orange-blue -yelow -red , Black and white joined together therefour weget 5 pin configuration and finally D0(ORANGE),D1(BLUE),D2(YELLOW),D3(RED)----- uNIPOLAR STEPPER MOTOR ---- 3.125 DEGRES PER ROTATION----- FINALLY HLAF STEP MODE GIVES THE HIGHEST TORQUE.......
The pin configuration of sl 100 is B C E with ground as the base of the transistor.
What is ift why we go for it.what are its applications
THE CONFIGURATION OF A THREE PIN WALL SOCKET IS THAT IT SHOULD BE WITH A SWITCH TO OPERATE THE PHASE THE NEXT SAME LEVEL PIN IS FOR THE NUETRAL AND THE THIRD TOP PIN IS FOR THE GROUND OR EARTH.THIS SOCKET IS USUALLY USED FOR ELECTRICAL HOME APPLIANCES LIKE COMPUTERS REFRIGIRATORS DEEP FREEZERS IRONS VACCUM CLEANERS MICROVAVES ETC ETC.
tel me the connections of 6wire stepper motor with 8051 microcontroller
4pin
The answser is White- black -orange-blue -yelow -red , Black and white joined together therefour weget 5 pin configuration and finally D0(ORANGE),D1(BLUE),D2(YELLOW),D3(RED)----- uNIPOLAR STEPPER MOTOR ---- 3.125 DEGRES PER ROTATION----- FINALLY HLAF STEP MODE GIVES THE HIGHEST TORQUE.......
Go to google.com and just type in the motor's model number and see what comes up. If that doesn't work, then try the manufacturer's name. Chances are very good you'll get the info you need.
Yes, most MCU's can not multi task it can run only one program at a time, so if you run a stepperor servo motor from one MCU it will slow down the whole program so, if you have send the command from the main MCU to the other one that is controlling the stepper or servo the main MCU can go on doing other things while the stepper MCU can take its time taking the stepper motor thru its paces If you have to run more than one stepper and using only one MCU, the MCU will have to drive the one stepper with one pulse and then the next stepper, you don't need a large MCU to drive a stepper only 4 bits is needed a 8 pin PIC like the PIC12F675 is all you need, GP0 to GP3 can drive the stepper while the chip can receive commands on GP5 that is a input pin only ,then you still have GP4 spare to drive a LED or a relay or you can use it as a DTR to send an interrupt to the main MCU and tell it that its done with the last command and ready for the next. A string of commands can be received by the 12F675 in serie on one pin and be stored in onboard EEPROM for use as needed
The pin configuration of sl 100 is B C E with ground as the base of the transistor.
the pin configuration of a processor means that the diagramatic representation of block diagram of processor representing various pins and the function of that pins
What is ift why we go for it.what are its applications
You need to put two 4-pin cables into the adapter as that provides the additional power that is required to drive a single 6-pin PCIe connection.
WHAT IS THE PINS CONFIGURATION OF 8086?
i think it secures our data from outside accessors
A: There is definitely a pin difference in configuration for each family of gates up to a point because of variety of gates available.