According to the EIA-96 system which applies to SMD resistors, it means 10K (10,000 ohm), 5% tolerance.
Variable resistor. The value of the variable resistor can be changed at any given moment.
No, because the power dissipated in a resistor is proportional to the square of the current through the resistor but only directly proportional to the resistance of the resistor (I^2 * R) and the current through the lower value resistor will be higher than the current through the higher value resistor, the lower value resistor will usually dissipate more power.
There is no relation between the resistor's ohms value and its size. The power of the resistor can be seen by its size. If the power is too small, the resistor can be destroyed.
if not disconnected you will measure the resistance of the circuit in parallel with the resistor.
A precision resistor is a resistor that has an actual value that is very close (or precise) to its nominal (or stated value). Therefore, precision resistors have a very degree of accuracy of being very close to their nominal values.
Resistor value is defined by the Resistance the resistor offers in Kilo ohms/ohms value given by color codes on the resistor.
Variable resistor. The value of the variable resistor can be changed at any given moment.
No, because the power dissipated in a resistor is proportional to the square of the current through the resistor but only directly proportional to the resistance of the resistor (I^2 * R) and the current through the lower value resistor will be higher than the current through the higher value resistor, the lower value resistor will usually dissipate more power.
There is no relation between the resistor's ohms value and its size. The power of the resistor can be seen by its size. If the power is too small, the resistor can be destroyed.
The first 3 band on a resistor indicate the value of that resistor.
if not disconnected you will measure the resistance of the circuit in parallel with the resistor.
It's a code to tell you the value of the resistance of the resistor.
It depends on what is wrong with the resistor. If it is damaged, replace it with the same type, value and power rating. If it is the wrong value and is not damaged, you can increase the value by placing another in series or reduce the value by placing another in parallel. If the resistor is variable type, you should be able to adjust it.
Greater value resistor will absorb more voltage than smaller value. The more voltage absorb with same value current flow, the larger body mass resistor will require. Body size depends on type of resistor (material resistor is made of).
A varistor is a variable resistor. It changes value dependent on the current draw and operates by changing its value as the resistor's temperature changes. For instance, during turn-on of a device, the resistor heats up causing the resistor to change it's value, thereby limiting the inrush current to the device. Once the initial start-up current is reduced and the device is operating normally, the resistor cools down and changes value again.
A hectoliter will yield 1E5 times more material than a milliliter, and would therefore make a line of atoms 1E5 times longer.
The phase angle will either go up or down as well, depending on the new value of the resistor.