answersLogoWhite

0

Remove the motor from the system. Get the motor rewound at a motor rewinding shop. Replace the motor back into the system. While the motor is at the rewind shop find out why the motor burnt out. The first thing that should be checked is the overload protection. Make sure that is is the same as the motors full load amps.

User Avatar

Wiki User

10y ago

What else can I help you with?

Continue Learning about Electrical Engineering

What kind of motor is used in an eram electric supercharger?

The motor used in the eram is a massed produced called the Johnson Motor. You can order them by the hundreds. Because of the motor that is used with the eram you will most likely only get 3 to 5 horsepower.


Can an ac motor generate electricity?

An ac motor cannot generate electricity but its shaft can be coupled to that of certain devices like an alternator to in order to generate electricity.


Can you by-pass a capacitor in an electric motor?

You can not by-pass the capacitor in an electric motor. Most are capacitor-start motors which require the capacitor to be operational in order to start. If the capacitor is not working then it will need to be replaced.


Why the rotor winding of a synchronous motor is usually connected to an external resistance during start up?

because at start the motor draws larger quantity of current and this may affected the rotor windings in order to limit current always resistance is connected.


What is locked rotor current?

"Locked Rotor Current" also called LRA which stands for Locked Rotor Amps, is commonly found on electric motor nameplates. Locked Rotor essentially means the motor is not turning. The current or amps in this case have to do with the amount of electrical energy required to start the motor. At the instant the motor is switched on, it is not turning, and draws the maximum current. As the motor starts to turn, the current goes down. This required energy is much greater than the Full Load Amps or Running Amps, which is the current drawn when the motor is running at normal speed under full load. The current required to start the motor will depend on the type of motor as well as the specified design voltage required for the motor, typically the higher the voltage, the lower the required amperage or current. The term also applies to equipment such as Air Conditioners which have an enclosed motor inside the compressor, as well as the condenser fan(s) etc. Depending on the type of motor, LR current can be anywhere from 3 to 8 times the normal running current, also called RLA, or running load amps.

Related Questions

What is the firing order for a Jeep 4.2 motor?

The firing order should be 1-5-3-6-2-4.


What is men's eee shoe width in inches?

My foot measures 4.75" wide and 10.75 long. What size boot should I order?


What is the firing order for a 5.9 liter Jeep motor?

The firing order should be 1-8-4-3-6-5-7-2.


Can you use regular gas in your CTS?

In order to preserve the motor in your CTS you should put only premium gas in it.


What is the firing order for a 1983 Cadillac DeVille?

the firing order on 83 deville with a 4100 v8 motor is as follows, 18436572. this firing order should also be in raised numbers on your intake manifold.


What safety measures should I take with asbestos removal?

Removing asbestos from your home is definitely something a trained and licensed professional must do. There are many safety measures that have to be taken in order to do this without harming or contaminating the environment. You should look up these types of professionals in your area and do research on them before you hire them.


What is the firing order of a Holden 202 red motor?

I have a 173, but it should be the same 1-5-3-6-2-4


What are the steps in rewinding of three phase motor?

To reverse a three phase motor, you simply swap two of the phase conductors.


In storing wine what other preventive measures should you keep in mind in order to keep its quality?

Store it in a dry place, without exposure to temperature variations.


Firing order 1970 Chevy pickup with a 350 V8 motor?

18436572 should be on the front drivers side tube on the top of the intake.


Why do you have standard measures?

Because in order to keep the same measurement


Can you ride a dirt bike without a license in nc?

In order to drive any motor vehicle a person must obtain a state issued drivers license. Without a license a person should not drive a motor vehicle.