suitable winding and correct power supply
The motor has a coil of wire that is an electromagnet. This causes the motor to spin, turning the fan blades.
In a modern coal fired power plant the mechanical motion of turbines is transferred by a shaft to a generator, where magnets spin within wire coils to produce electricity
An electric generator converts mechanical energy to electric energy while a motor converts electric energy to mechanical. A generator can actually act as a motor if it losses whatever is making it spin (called "motoring"), which is usually a very bad thing. Motors may be used as generators as well, depending on their design.
A synchronous motor will spin at the system frequency. 60 Hz translates into 60*60 = 3600 direction changes per minute. If this is a two pole motor (one north and one south), it will spin 1 rotation per direction change. If it is a four pole motor (two north and two south), it will spin 1/2 rotation per direction change. If this is an induction motor, it will spin at a frequency slightly less than an equivalent synchronous motor; this frequency difference is referred to as slip.
A simple Rotary phase converter is just a motor generator set. An electric motor running on the input voltage/current/phase/frequency. it drives a generator that supplies a different voltage/current/phase/frequency. So an electric motor and an electric generator connected together mechanically, either on the same shaft, or via gears, constitutes a Rotary phase converter. the above is incorrect, the motor/generator is the same motor, just one 3 phase motor is needed, it will run on T1 and T2, and put out L1, L2, and L3. You just need to know how to wire it up and what to do to get it to spin over on simple single phase 220, it will create three phase 220.
In order for an electric motor to spin freely you will have to make sure you have one thing. You have to have the electric current for the motor to run freely.
Use an electric motor.Definition for electric motor:Web definitions:a motor that converts electricity to mechanical work.wordnetweb.princeton.edu/perl/webwn
The rotor (which is some type of magnet).
Switching the field voltage to the coils forces the magnets to move.
A motor is a mechanism that spins by means of electric energy and uses magnetism to spin. It uses energy.
True. In an electric motor, a magnetic field causes a current-carrying loop to experience a torque that makes it spin. This spinning motion is the basis of how electric motors convert electrical energy into mechanical energy.
Electromagnets are used in the electric motor of a fan. The magnetism created by the electric current in the core of the motor interacts with a fixed magnet, causing the motor to spin and drive the fan blades. This rotation creates airflow, producing the wind or breeze effect.
Most fans have an electric motor that runs off of electricity. These use magnetization to spin the fan
A motor can be connected up to a car battery to store the power produced when it runs as a generator, but you will find that when current is drawn the motor needs more work to spin it, it will not spin so easily. That is because of conservation of energy.
You need, a electric motor, a power source (battery), blades or propeller to attactach tot he motor so when they spin the move (displace) the air.
I would say that either the bearings in the motor are worn out ,so the motor has a hard time turning. Or it may be that one of the motor windings (electric coils) is bad. I would replace the disposer.
The motor is electric, the hot water is typically heated by gas or electric.