0
The error code 070E on a 60PB Megger AVO during an oil dielectric test typically indicates a fault or issue with the test setup or the dielectric fluid being tested. This could be due to a low insulation resistance, incorrect test voltage, or a configuration error in the testing equipment. It's important to verify the test parameters and ensure the oil sample meets the required standards for testing. If the error persists, consulting the device manual or technical support may be necessary for further troubleshooting.
What else can I help you with?
Continue Learning about Electrical Engineering
Related Questions
Trending Questions
How do you calculate rated kva of a circuit breaker?
If the resistance of a resistor is 6 ohms what is the conductance?
Can indoor Romex wiring be used outdoor as long as it is inside of PVC conduit?
How did alessandro volta invent wire?
How can you prevent the buildup of static electricity while fueling your vessel?
What is the CPT code for Electrical Stimulation?
Is voltage and current are proportional?
Why ac megger not use in cable meggering?
What are Resistors wired in series?
What color is the ground wire on power tools?
Why are household electric wires covered with plastic or rubber?
What are connectors?
What will happen if you place too many washers on the end of a shaded-pole motor shaft?
What did thomas telford invent?
What is under current relays?
When a conductor cuts magnetic flux an emf is induced in the conductor. This is known as?
When temperature increases voltage across diode with constant current?
Why are wind turbines not placed next to one another?
What is doping process?
What is the PCB and its location?
Copyright ©2025 Answers.com. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.