answersLogoWhite

0

describe how to use starting resistors to star a DC motor

User Avatar

Wiki User

14y ago

What else can I help you with?

Continue Learning about Electrical Engineering

Which motor has high starting tourque?

Series motors have the highest starting torque. The torque is proportional to the square of the current, and the starting current is so high it has to be limited by a resistor called a rheostat. Series motos are used mainly on trams and trolley buses.


What is the common application for capacitors in electric motors?

There are 2 types of capacitor including starting capacitor and running capacitor running capacitor are used to improve the power factor of motor. starting capacitor used in split phase induction motor . starting capacitor may isolate from motor,s starting winding through of centrifugal switch after getting motor 90% of it,s rated speed.


What type of motor is used in centrifugal pump?

3 Phase induction motor because it produce high torque at starting


What is a braking resistor?

A braking resistor is used in motion systems where a motor in controlled by a drive. Typically, these are high-speed servomotors controlled by a servodrive. When accelerating, electrical energy is converted to a mechanical force to move a mass. When decelerating, that kinetic energy is converted (via the motor) back into electrical energy, and must go somewhere. To brake quick enough, the energy must be dumped into a power resistor, to be dissipated as heat. Read more at the link provided below.


What type of induction motor is used in table fan?

Motor used in Table Fan is Split phase Motor(Continuous Running with Capacitor).It has Two winding Running coil + Starting Coil. Running coil connected Direct to Supply Starting coil Connected is series with capacitor than parallel with power.

Related Questions

Which motor is used in automobiles for starting purpose?

A DC series-parallel compound motor.


What is general purpose resistor?

General purpose resistor is used to resist the current flow.the common resister is general purpose resister.


What is a resistor block for on a Dodge Caravan?

The resistor block or blower motor resistor is used to control the speed of the blower motor. That is how you get the lower speeds on your air conditioning or heater. The higher the resistance the lower the speed of the motor.


Where is ballast resistor on Dodge Grand Caravan sport 2002?

It does not have a ballast resistor, those were used for ignition systems 30+ years ago. It does have a blower motor resistor that is located behind the glove box.It does not have a ballast resistor, those were used for ignition systems 30+ years ago. It does have a blower motor resistor that is located behind the glove box.


Which motor has high starting tourque?

Series motors have the highest starting torque. The torque is proportional to the square of the current, and the starting current is so high it has to be limited by a resistor called a rheostat. Series motos are used mainly on trams and trolley buses.


What is the purpose for a blower motor resistor?

It it used to regulate the blower motors speed. If this goes bad, you will completely lose function of a certain speed, or overall. If this happens, you will need to replace the switch and or board.


What is a HVAC Resistor Pack and where does it go?

The HVAC resistor pack is used to provide the various speeds of the blower motor for heating and A/C. According to other sources, the resistor pack mounts to the rear of the blower motor, which is located under the passenger side dash.


Why does fan goes slower when resistor is on?

A resistor used in a fan circuit reduces the voltage supplied to the fan motor, which decreases the speed of the fan. The resistance introduced by the resistor limits the current flow to the motor, resulting in a slower fan speed.


Which types of resistor is commonly used in motor vehicle circuits?

Mainly carbon film no doubt.


Which motor is used for starting engine?

Er... a Starter Motor?


What is need of capacitor and resistor in circuit?

because without using capacitor or resistor in a circuit,it cant be complete.Resistor is used to protect the circuit by giving a certain amount of voltage.Capacitor is used to charge and discharge purpose.


Why ac motors are not used in railways?

Ac motor has a low starting torque so that DC series motor used in railways cause DC motor has high starting torque