The life span of the wiring in a typical house is between 60 to 80 years. The main electric service should be replaced about every 30 to 40 years.
Not necessarily. It would depend on the condition of the wiring. If it is an older house with cloth covered wires it may be advisable to rewire. If existing wiring is aluminum you might also consider rewiring. Depending on the length of wires that enter the current box, you may need some external junction boxes.
The end sockets have to be rewired. The schematic for the rewire is on the ballast label.
The usual procedure is to remove the old wire and replace it with new wire.
About the same as it costs to rewire a small 3 bedroom house. -For an exact quote, call a LOCAL electrician. Rates vary all over.
If there is no ground wire connect the ground wire to the neutral wire.
The cost to rewire a house typically ranges from 3,500 to 8,000, depending on the size of the house and the complexity of the job.
No they should be fine.
Not necessarily. It would depend on the condition of the wiring. If it is an older house with cloth covered wires it may be advisable to rewire. If existing wiring is aluminum you might also consider rewiring. Depending on the length of wires that enter the current box, you may need some external junction boxes.
Make sure that everyone involved in the project is properly licensed. Ask about the level of insurance held by the principal or company. Get two or three estimates for the work as well.
The rewire a panel box you will need to hire a trained electrician. This is a job that should not be handled by untrained individuals.
To effectively rewire an old house for safety and compliance with modern electrical standards, hire a licensed electrician to assess the current wiring, replace outdated components, install ground fault circuit interrupters (GFCIs) in wet areas, update the electrical panel, and ensure proper grounding and insulation.
eHow is a great resource for topics like this, with articles like "How to Re-Wire a Lamp," "How to Rewire a Lamp with a Rotary Switch," "How to Rewire an Old Lamp," and "How to Wire a Floor Lamp."
Rewiring is easy
which model?
Yes, if you rewire the bed and rewire the plug on the wall to 220 volts.
Type your answer here... Why are you wanting to rewire the brake lights?
The end sockets have to be rewired. The schematic for the rewire is on the ballast label.