A: A swamp cooler uses water flow to control temperatures as the water flow increases the transfer function increases. So yes it will effect the temperature. but for humans at the same time more water in the air will effect our perspiration and cooling in effect basically it will reach an equilibrium whereby more water will not cool us any further. A 70 degrees and 100 % humidity is hotter then 85 degrees dry heat
Yes you can use a rheostat to control the speed of an ac motor as long as it is correctly sized (power). A better way would be to use a triac control.
The speed control of the DC motor is important because its speed can be changed over a wide variety of simple methods which is not possible in an AC motor.
An SCR chip is commonly used to control the speed of a motor. The speed is controlled using an AC circuit and phase angles.
The flux control method is the convectional and the non-convectional method of speed control of an induction motor.
slip speed control refers to induction machines s=(synchronous speed-motor speed)/synchronous speed by varying slip the machine can be either be operate in generated mode or motor mode
No. If you attempt to reduce the voltage to a cap start motor by using a rheostat, you can destroy the motor.
Yes you can use a rheostat to control the speed of an ac motor as long as it is correctly sized (power). A better way would be to use a triac control.
A Potentiometer, an adjustable resistor, is connected between the power source and the motor. An AC motor would use a Rheostat .
By varying the Resistance to the motor. These Devices are called RHEOSTAT'S
Putting a rheostat in series with a motor is not necessarily the best way to control the motor speed. The rheostat works by converting what electricity would have been going to the motor into heat. An audio rheostat would need to be sized appropriately. Putting a rheostat in series with a synchronous motor that is found in some fans is not particularly good, either. Since the motor is phase-locked with the alternating current would simply make the motor turn with less power at the same speed until it starts 'tripping over itself'. That leads to overheating. A better option is to use a solid-state motor controller. That delivers full voltage to the motor but rapidly cycles on and off. As you turn the controller up the power is more on than off.
The speed of a dc motor can be regulated by the following means:By varying the supply voltage and byUsing a variable rheostat.
the motor should only rotate in a rated speed,if the speed is more than rated speed then the motor will be damaged........to control the speed of motor a rheostat should be connected to the field side of motor......by variying the rheostat we can control the speed of motor......
It is used for sensorless motor control. With vf speed control u can control speed of any induction motor.
It is used for sensorless motor control. With vf speed control u can control speed of any induction motor.
The speed is varied by throttling the air flow into the motor.
The speed control of the DC motor is important because its speed can be changed over a wide variety of simple methods which is not possible in an AC motor.
An SCR chip is commonly used to control the speed of a motor. The speed is controlled using an AC circuit and phase angles.