The PCM (Powertrain Control Module) 20 amp fuse is typically located in the fuse box under the hood of the vehicle, often near the battery. In some vehicles, it may also be found in the interior fuse panel. To locate it specifically, refer to the vehicle's owner manual, which provides a diagram and details on the fuse box layout.
20 amp on a 12 volt system
Use a 20 amp fuse or breaker.
No. If you use a larger fuse you are not protecting the device which has a rating of a lesser value.
4800
It is a fuse that is rated in one thousandths of an amp. An example, a 500 mA fuse can also be called a 1/2 amp fuse.
In the Power Distribution Box ( which is " live " ) in the engine compartment : Mini fuse # 1 is a 30 amp fuse for the PCM relay Mini fuse # 2 is a 10 amp fuse for the PCM and front electronics module Mini fuse # 5 is a 15 amp fuse for the PCM and fuel pump motor
In the power distribution box, in the engine compartment of a 1997 Explorer, (PD BOX IS LIVE - DISCONNECT YOUR BATTERY CABLES ) in location # 2 there is a 30 amp maxi-fuse for the PCM power relay in location # 11 there is a 20 amp maxi-fuse for the PCM MEMORY and horn Relay# 5 is the PCM POWER RELAY and diode # 2 is the PCM DIODE ----------------------------------------------------------------------------------------------------------- In your fuse panel - visible with the driver's door open location # 13 - 15 amp fuse - for PCM system/stoplamps/AWD/ABS/speed control/ trailer tow location # 19 - 25 amp fuse - for PCM system/ ignition coil
They should be in the engins compartment fuse/relay panel.
I have seen a bad starter do this
20 amp body fuse 20 amp body fuse #15 on the fuse block 25 amp body feed fuse
The 1965 Chevrolet Impala SS fuse box requires a 20 amp fuse for the taillights. A 30 amp fuse can be used when a 20 amp fuse is not available.
fuse number 1 is 10 amp fuse 2 is 25 amp fuse 3is 25 amp fuse 4 is a spare fuse 5 is 10 amp fuse 6 is a spare fuse 7 is 20 amp fuse 8 is 25 amp fuse 9 is 20 amp fuse 10 is 5 amp fuse 11 is 5 amp fuse 12 is a spare fuse 13 is 5 amp fuse 14 is 15 amp
20 amp a 20 amp fuse
In the power distribution box in the engine compartment ( which is " live " ) Maxi-fuse # 11 is a 20 amp fuse for the horn and the PCM memory Also , relay # 2 , in the PD BOX is the horn relay
The purpose of a fuse it to protect the wire that goes to the load. A 15 amp fuse protects a #14 gauge wire. A 20 amp fuse protects a #12 gauge wire. To answer your question if the wire size is #12 coming from the 15 amp fuse now then it can be upped to 20 amp fuse. If it isn't then you are taking the risk of overloading the #14 wire with a 20 amp fuse. This can lead to insulation failure of the #14 wire, overheating with the possible outcome of a fire breaking out somewhere in the circuit.
The maximum current rating for a 20 amp fuse breaker is 20 amps.
It should be a 25amp fuse. start checking coils, or PCM.