I would have to say the 0 guage. It's heavier and if your strong enough you could swing it at someone pretty hard. It would have to hit the person harder than the 4 guage.
3/0 gauge
As far as I know there is no -33 gage wire. If you meant + then that would be the thinnest so 0 is the answer
I would recommend you use 1/0 gauge
At the service entrance you will need AWG 1/0 gauge.
As a service entrance wire you need AWG # 3/0 gauge copper.
3/0 gauge
on a 4000 watt amp the best gauge wire woul be between 2 and 0
The recommended wire size for a 100 amp breaker is typically 2-gauge copper wire or 1/0-gauge aluminum wire.
the answer is gauge its a measurement of thickness in wire the 4 gauge (ga) wire ran from my car battery to power my audio amp. the smaller the number the bigger the wire usually from 24 gauge to 1/0 gauge which is about a inch thick
I would recommend you use 1/0 gauge
As far as I know there is no -33 gage wire. If you meant + then that would be the thinnest so 0 is the answer
The recommended wire size for a 200 amp electrical circuit is typically 2/0 or 3/0 gauge wire.
At the service entrance you will need AWG 1/0 gauge.
As a service entrance wire you need AWG # 3/0 gauge copper.
150MCM wire is typically equivalent to 0.5335 inches in diameter and is approximately equivalent to 4/0 AWG.
Copper wire gauge sizes are not equivalent to aluminum wire gauge sizes. The gauge sizes for copper and aluminum wires are different due to their differing electrical conductivity properties. It is not possible to directly convert a copper wire size to an equivalent aluminum wire size.
Depends on the size of the service. 100 amp service will require 3 gauge, 150 amp service will require 1/0 gauge, and 200 amp service will require 3/0 gauge.