DC has polarity, while AC is constantly reversing in polarity.
AnswerWhile the previous answer is quite correct in the sense of 'positive' and 'negative' charges, it's worth pointing out that 'polarity' has a second meaning in a.c. systems.In a.c., the term 'polarity' is used to describe the correct connection of the supply's line and neutral terminals. For example, with an Edison screw lamp holder, to remove the risk of shock, it's important that the line conductor is connected to the centre terminal, and the neutral conductor is connected to the outer terminal. If this has been done correctly, then we say that its 'polarity' is correct. Similarly, if the terminals of a socket outlet (receptacle) are connected the correct way around, then their 'polarity' is correct. Testing for the correct connections in an a.c. electrical system is called a 'polarity test'.
when the dc supply given, dc load line lies in the Ic and Vcc. when the AC supply given, AC load line lies in the Ic and Vcc.
If having DC and AC is required then a PWM pulse width modulator is required to chop the DC to make AC
The type of power supply being used (AC or DC) should match the power requirements of the device it will be supplying power to.
DC 12V power supply can convert 110/220V AC power source to 12V DC.
"Voltage peak" is generally used to denote the maximum(amplitude) of AC voltage supply. It can not be approximated as dc value. The closest approximation one can make for dc value of a ac supply is the RMS(root mean square) value of the voltage. So that the ohmic loss caused by the given AC voltage supply is equivalent to that caused by a dc supply having value equal to the RMS of this AC supply (for given impedance & time).
As we touch an ac supply in which due to body resistance , we create a phase difference between the ac supply and us . As ac reverses polarity , so do we , but our polarity change is opposite to that of the polarity change of ac supply , hence our body gets attracted to the ac supply .
AC means alternating current DC means direct current there is no polarity reversal
You can weld with E6013 using any polarity. Use DC - or AC for thin sheet metal. Use AC if you have arc blow problems. DC - has the lowest penetration DC + has the most penetration AC splits the difference
we can convert a dc supply to an ac supply using inverters. Its a common operation which we observe in our daily lives dc can be converted to Ac using an undulator.
the universel motor can runs at both ac and dc supply.
Radios use DC power supplies to operate. If a radio is powered from a mains AC supply, a power supply circuit will convert the AC supply to DC. Therefore, a radio may have both a DC and an AC power input but ultimately, the internal circuitry will always use DC.
ac supply converted with dc supply
ac supply converted with dc supply
dc power supply
when the dc supply given, dc load line lies in the Ic and Vcc. when the AC supply given, AC load line lies in the Ic and Vcc.
If having DC and AC is required then a PWM pulse width modulator is required to chop the DC to make AC
because the transmission cost of ac supply is lesser than dc. thats why ac is prefered